Utilisateur

I installed an EVO-One in my 2020 Telluride. I am using the RM912 and ANT900 kit. I updated firmware on the antenna and the EVO module. All wires seem to be correct per drawing. I was able to program the bypass when you first hook up all connectors, and I got the two remotes programmed to the antenna, however the manual says to hold the single button for 12 seconds or until the blue LED turns off and then comes on SOLID. The Blue LED comes back on RED for me. The manual does not specify what color it should be when it comes back on solid, but maybe red is a bad sign? I try to use to 912 fobs and nothing happens. No lights on the EVO or antenna. The fobs blink blue and then turn red and chime a few times. I can use the factory Kia fob to lock/unlock and the blue LED on the EVO blinks when doing this. The yellow light on the EVO is constantly on when the car is running or ignition on. I never see any other lights blinking on the EVO though. The Antenna LED will blink very fast right after locking the door with the factory fob. In about 10 seconds or so, the horn and park lights flash 3 times and the blue LED on the antenna then blinks slower. It is programmed as a push to start automatic car, so I am not sure what 3 honks really means. The car still stays locked. No matter what I try with the two RM912 remotes, they never get a green light, the antenna or EVO mdule never blinks blue when the 912 fob is used, and nothing ever happens with door locks or starter. Almost seems liek the fobs do not work at all, but to try and test that theory, I set the ability to remote start the car using the factory fob with 3x lock button, but that does not work either. I have the yellow loop cut, the hood is closed (grounded) and doors are all closed. I am wondering what to do?