Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

2023 tundra install

i already have an evo one all from my old car and have a few questions 1) will the THAR-ONE-TOY16 work on my 2023 tundra since is the same as the 2022 and the start x remote start which is just an evo one works on both? 2 where do the diodes go i dont see them on the diagram 3) what is the THAR-TY120 is that an additional harness or is it built into the main harness cant seem to be able to google an answer i realy want the remote start to be able to control the doors on the cellular app and start x says there's cant even though its just a rebranded evo one and comes with a fortin programer also its cheaper to get the harness than get the whole start x kit since i already own a evo one and a cellular module

0

Tundra Starts but door do not unlock with fob

2021 tundra Starts with oem fob and evo start2 but the fob doesn't unlock the doors

0

Tundra parking lights

I have a evo one on my tundra. Is there a way to not have the parking lights come on? It flashes the parking and tail lights after I un lock or lock the door.

1

2020 Tundra OEM alarm orange wire spliced in?

Hard to tell from install guide. For OEM alarm, does the orange wire need to be spliced into the wire? Does it matter whether it is spliced into the original plug or the T-harness?

0

2020 Tundra how do I make the engine not turn off when I open the driver's door?

Successful install, 2020 Tundra PTS, Evo-All, 79.69 Bypass FW, T-harness, RF642W remotes. Remote start works just fine. As soon as I open the driver's door the engine shuts off. Tried even unlocking before opening but still shuts off upon opening. How do I put an end to this?

0

2008 Tundra 3x oem remote start using Evo one stand alone

Is it possible to use the Evo one stand alone and the oem fobs on a 2008 tundra dot key? If so how to configure the Evo and what extra connections need to be made. Thank you.

0

16 Tundra, Evo Key, no start

Used connection 5, programing 3 in manual. Wires were easy to find, did not use key sense. Believe truck does have a factory alarm (If that matters), it does have a factory keyfob. Programming does what it says it will do. Remote start is a Viper. Everything remote starts fine if I leave the key in the ignition. If I don't, security light blinks and remote start doesnt work. I have the flash link and everything was already updated, and it didn't give me any options to change or adjust anything. Just update. GWR is connected to the Viper. Only the red light comes on the EVO Key if I remote start it. Is this normal? I'm sure im forgetting something.

0

2019 & 2017 Toyota Tundra crank no start, starts sometimes

I had 2 installation today on 2019 & 2017 Toyota Tundra, both had same issue. Both trucks would crank only with no start. But sometimes it would start during the first remote start attempt and sometimes it would start on the 2ed attempt after the first attempt timed out. I used a crimestopper RS4-G5 with an Evo-All. I have installed many units over the years and I dont think it is a coincidence that I had the same issue with both trucks. Is there anything I could have done wrong for this to happen. I even changed the communication protocals on to see if that would help and it did not.

0

2007 toyota tundra evo-one install with fortin remote sets off alarm at remote start

Alarm worked fine for a couple of days after the install. Now 3 times out of 5 it triggers the oem alarm when trying to remote start. I checked the light green wire(disarm) and it seemed to get good connection.

19/01/2021

Toyota jbest (300Pts.)

0

2006 Toyota Tundra Standard key, No guide

Hi, I want to install a EVO-ONE into a 2006 Toyota Tundra with immobilizer system. The Fortin website does not show a guide, yet it indicates compatibility. Is there a guide available for this vehicle? Thank you.

0

2021 Tundra PTS solution

Hey Guys ! Do yo have any idea on when PTS Tundra will be supported ? Got many request from customers... Thanks in advance

0

Tundra G key 2010 Final program fail

2010 Tundrea with G key. Harness bought so no cutting/soldering of wires. I get to the final stage (this has been going on for weeks) and I connect the unit with the big white cable whilst holding the program button in. The lights flash as they should red/yellow/blue.I stop on red and blue. I then connect the 3 remaining cables larger white, smaller white and red. Press the program button twice and the red blue light flashes and never completes.IF I enter the key and turn the igntion on before pressing the progrsam button twice it DOES complete but then the truck cranks but does not start as it is still immobilsed. So have run out of ideas on this. Secondly I bought a flash link and had it sent to Asia where I live and this is now showing "limit reached"??This is service l number 002504 07557 for Evo One module serial number 002B04 015151. So can you help with the program problem and also reset my Flash Link. I am 12 hours ahead of Canada so "calling" cusstomer care from the other side of the world does not work. Thanks for any help you can give

0

Replacing broken evo one unit with another on a 2010 Toyota Tundra.

My evo one was working great in my 2010 Toyota Tundra standard keys for about 6 years. When installing a new my car unit, I accidentally broke one the connector from the evo one unit. So I got another evo one unit and install it. I could not program the evo one with the newer guide. I think my t-harness was a toy1. So I got it to programmed with the blue light, turn the key, and the blue light flashed rapidly. I got the vehicle started 1 and it never start again. The red light by the programming button flashing. I don't think it does that before. Please help

0

Why does my factory alarm activate on remote start 2018 Toyota Tundra?

0

Accessories or radio does not turn on with remote start- fortin evo one t-harness

My accessories i.e. radio, usb plug in do not turn on with remote start. I sit in with and turn key in ACC, radio and accessories turn on. Once I turn the key in IGN, SRS airbag light stays on. I believe once accessories and radio are able to turn on with remote start, SRS airbag light issue will resolve. I have the T-harness, mycar and long range remote as well. How do i wire this up so accessories, radio and even A/C turn on with remote start?

0

2013 Toyota Tundra starts for a few seconds then shuts off

I have tried everything. I am pretty sure it's programmed correctly. It starts then shuts down seconds later. I am all out of ideas and ready to give up. Service number 002BO7 339682

0

Help with addding ASCL6 module using Flashlink

I purchased an Evo One a few months ago to add the ASCL6. Thought it was as simple as just plugging it in. Found out you need to purchase the Flashlink to set this up. Did that. Have no idea how to go from here. When I start the program it goes straight to asking me details of my vehicle:make, model, transmission, OEM alarm, System Setup, OEM remote, etct. Where or how do i add the ASCL6 optioin. I've tried everything and can't see to find the option to get this done.

1

2020 tundra h key tpms wire

do you have an updated wire location for the 2020 tundra tpms wire? 18-19 shows pink wire on the 20pin white connector in the lower kick panel and the 2020 wire at that location is not pink and is not for tpms.

0

2019 Tundra Platinum Tilt/Telescoping Steering Wheel and Fog Lights

Just got the Evo-One and the THAR-ONE-TOY10 harness for Christmas. Installed it and everything seems to be functioning except for 2 items. -Fog Lights. Those no longer turn on. Doesn't matter what mode the headlight switch is in, the fogs will not come on. -Power Tilt and Telescoping Steering Wheel and Power Seat. When you put the key into the ignition, the steering wheel will come out to your setting, along with the seat will move, This still works if the truck is off before inserting the key, but when it is remote started, this no longer works, and you have to press the memory button to reset the locations. There was a similar question listed here, which had a workaround, but that unfortunatly does not work in my truck. Thoughts? Are these firmware issues?

0

2020 tundra h key tpms wire

do you have an updated wire location for the 2020 tundra tpms wire? 18-19 shows pink wire on the 20pin white connector in the lower kick panel and the 2020 wire at that location is not pink and is not for tpms.

1

tundra 2006 immobiliser bypass

Hi, I have A 2006 toyota tundra cnd spec with factory immobiliser, on the website, it only give int-sl+ which only do the door lock, tried a used keyoverrideall like the diagram for the 2006 toyota sequoia (which is almost the same truck) but it doesnt work, it wont program, is there another option or do i need a spare key to make it work? thank you

0

Fortin Evo one plus RFk942 can’t get it work 6 hours of trying 2014 tundra

Ok here is the basics I have the eco one hardware 2.xx I just updated the firmware in the bypass and the other section. Forgive me I'm tired and can't remember.

"As for the RF kit, the only option you need enabled is RFLF in the remote starter options". As per the instructions "Press and hold the valet switch until the parking lights turn ON, the horn/Sirn will chirp"  this does not happen.   Step 2 works "Press and hold the valet switch or the antenna but- ton until the Parking lights turn ON, the horn/siren will chirp" But thats to "ERASES ALL REMOTES THAT HAVE BEEN PROGRAMMED AND RESETS ALL FUNCTIONS BACK TO DEFAULT."



 

i have no idea what I am doing wrong? I can't get past step on by pressing the recently connected valet button to start the RF kit instructions.  I also Don't see "RFLF" anywhere in the flashlink updater 

my problem is I don't think my valet switch is working.  I had been using the OEM Toyota 2 button remote for years.

when I originally installed and programmed the Evo One the valet switch was not installed.. could this be a problem?

0

2011 tundra just cranks. Using Evo one with toy7 harness and Evo start2.

Installed Evo one with Evo start 2 mobile using tharness toy7 on a 2011 tundra h-key. All settings set up correctly. Tapped into key sense wire for factory alarm and tapped yellow wire from mobile antenna to pink wire on ignition harness. Unable to program the remote that comes with it and when I remote start with factory key fob car just cranks...it starts if I put the key in the ignition but then I am unable to turn Off the car without unplugging the Evo one. Any ideas?

0

When my autostart times out and shuts truck off, the alarm goes off, how do I disable this?

Using the EVO-ONE with the T Harness, When the autostart times out and shuts the truck off, it will sound the alarm. How do I configure things so that the truck will shut off and return to a normal OFF state? So far this thing is fantastic, I love it! Also, where do I learn more about what I can do with it? I have the RF remote kit, and there is an accessory button on the remote, I'd like to use that to install a tailgate popper. Where do I read about how to use all the feautres avaialble on this wonderful thing?

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer