English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

29/01/2024

 Toyota naftali20 (130Pts.)

0

Remote starter cranks but won't start after unlocking car when battery was disconnected

I disconnected the battery on my 2016 corolla L, and used the key to manually lock and unlock the car. I seem to have Jiggled something in the lock, because since then the starter cranks but won't start (bypass issue).
Connectez-vous pour répondre Voir 1 réponse(s)

25/11/2023

 Toyota KIEN MACH (210Pts.)

0

2011 Sienna crank, no start when COLD

Hi support team, My 2011 Sienna G-key start all OK in summer, but it doesn't work when WINTER is coming. S/N 002B04 241048 connected by THAR-ONE-TOY9 (just plug and play). I did connect 2 wires for sliding doors by soldering and crimper (no T-taps). Already upgrade to latest firmware. Tried TACHNESS ONLY but no hope, still CRANK but NO START. I'm connect with RFK442 remote. It happened to me last year, same issue. Work fine in the summer but when it's cold out there, the vehicle just CRANK NO START. When I get into the vehicle and remote start it, leave the key next to the key cylinder, it start right up every single time. Moreover, I've re-checked the wiring connection. There are "CUT" at the SILL data (D4&D6) and the AUTOLIGHT (D1&D3). Do I need to do anything about these "CUTs" when I'm using THARTOY9? Thank in advance for your support.
Connectez-vous pour répondre Voir 1 réponse(s)

25/11/2023

 Toyota John Benedetto (130Pts.)

0

2001 Toyota Avalon Cranks but no start EVO ONE with T harness and RM442 remote

2001 Toyota Avalon. Installed per instructions with T harness, flashed using wizard, all showed good. Key sense connected to Red/yellow per wirecolor.com (not red/white as shown in install diagram as there is no red/white). Also verified this red/yellow key sense pulls to ground when key is inserted. Key bypass seemed to program correctly, red LED flashed rapidly after inserting key. Made connections to door locks, trunk, and parking lights, all which work fine. I press the remote start and the car will crank but does not start. Seems like it is not properly bypassing the key.
Connectez-vous pour répondre Voir 1 réponse(s)

22/10/2023

 Toyota Munito (1450Pts.)

0

2011 Toyota Camry remote starter engine cranks but won't start.

Hi guys, my again over here, almost winter and ppl locking for install remote starter in they cars. I am trying to install an EVO ONE with a k411 RF module in a 2011 Toyota Camry but it does not send the start pulse. This has happened to me on two 2011 Toyota Camrys, exactly the same problem. It is not a type G key, it is a standard key. I am using the same guide: https://fortin.ca/download/81181/EVO-ONE_IG_REG_BI_TOY-CAMRY_KEY_2007-2011_A_81181.pdf I used the same installation wiring and the same programming on both cars, but the result was the same, the car does not receive the start pulse. I have already seen that someone on the forum had a similar problem and they did not give a concrete solution: https://fortin.ca/qa2/121279/2009-toyota-camry-remote-starter-engine-cranks-but-wont -start Here I share the video with the problem and the data of the car and the EVO ONE module to see if you can help me: https://drive.google.com/file/d/1RQyDUUYFEomx9kqWpx2LhHOuaz0FOUmN/view?usp=sharing Module: EVO ONE S/N: 002B04339802 Car VIN: 4T1BF3EK6BU678116 Thank you very much for advance.
Connectez-vous pour répondre Voir 1 réponse(s)

15/05/2023

 Toyota Joseph Amaechi (130Pts.)

0

2009 toyota camry remote starter engine cranks but won't start.

Hello I recently ran into an issue where when I try to remote start the car, the engine cranks but won't start and my evo one won't master reset either and I really need help to get it fixed please. And my oem key doesn't unlock/lock the car or start the car either. The S/N is 002B04 327767
Connectez-vous pour répondre Voir 1 réponse(s)

07/01/2023

 Toyota Edrice Iraola (1090Pts.)

0

2009 corolla standard key cranks but won’t start.

I have 2009 corolla (standard key) Evo-All SN#001A07-362341 followed guide 81121 with crime stopper sp04 Engine cranks but won't start,please help,thanks car will start if i put key in barrel. also i noitce red led does not turn on during remote starting
Connectez-vous pour répondre Voir 2 réponse(s)

17/11/2022

 Toyota Scott Chalupnik (170Pts.)

0

2020 Tundra cranks but won't start

2020 Tundra cranks but won't start. Truck has Hkey, anti theft system w/alarmand engine immobilizer. I loaded recommended settings. Orange wire IS spliced into THar-ty10 #2 harness wire. Set up is Transmission -Automatic, OEM Alarm-Yes, System setup- Remote starter only, OEM Remote- 3x lock, RF kits- NO, Remote starter runtime- 7mins, Connection- Thar-One-Toy10, Installation method- Immobilizer bypass. SN 002B04 162783 When cranking I can see the vehicle security light blinking(if that means anything)
Connectez-vous pour répondre Voir 1 réponse(s)

08/09/2022

 Toyota Phil Rochette (160Pts.)

0

2012 Sienna EVO One Thar toy9 crank no start and no headlights

2012 Toyota Sienna G-Key with EVO-ONE & THAR-ONE-TOY9 & THAR-ONE-TOY1 & RF642W. EVO-ONE & THAR-ONE-TOY9 & THAR-ONE-TOY1 & Rf642w The car cranks but does not start when remote started. It does start manually with the evo one isntalled. The RF kit was put in mode 1. After having pluged installed the EVO-ONE with the harnesses, the headlights dont work, turn signals are fine. When programming the rf kit only the instrument cluster lights blink, not the healights and no horn. service # 002B04044516
Connectez-vous pour répondre Voir 1 réponse(s)

10/12/2021

 Toyota Alex Jackson (130Pts.)

0

16 Tundra, Evo Key, no start

Used connection 5, programing 3 in manual. Wires were easy to find, did not use key sense. Believe truck does have a factory alarm (If that matters), it does have a factory keyfob. Programming does what it says it will do. Remote start is a Viper. Everything remote starts fine if I leave the key in the ignition. If I don't, security light blinks and remote start doesnt work. I have the flash link and everything was already updated, and it didn't give me any options to change or adjust anything. Just update. GWR is connected to the Viper. Only the red light comes on the EVO Key if I remote start it. Is this normal? I'm sure im forgetting something.
Connectez-vous pour répondre Voir 1 réponse(s)

05/12/2021

 Toyota Ariel Taveras (630Pts.)

0

2019 & 2017 Toyota Tundra crank no start, starts sometimes

I had 2 installation today on 2019 & 2017 Toyota Tundra, both had same issue. Both trucks would crank only with no start. But sometimes it would start during the first remote start attempt and sometimes it would start on the 2ed attempt after the first attempt timed out. I used a crimestopper RS4-G5 with an Evo-All. I have installed many units over the years and I dont think it is a coincidence that I had the same issue with both trucks. Is there anything I could have done wrong for this to happen. I even changed the communication protocals on to see if that would help and it did not.
Connectez-vous pour répondre Voir 1 réponse(s)

30/01/2021

 Toyota Gring Yang (160Pts.)

0

2011 tacoma G-KEY cranks only no start 4x parking light flash

After installation and programming evo one went to remote start with RF642W, truck only cranks but does not start, evo one automatically did a 2nd attempt but still no luck...Counting the 4x parking lights its inidicating that its either not sensing tach signal (i figure connections are good since managing to go through all programing steps, second guess is its in valet mode, i turned off valet mode by turning ignition on and 3x pressed valet switch but still no luck. any figures ?
Connectez-vous pour répondre Voir 1 réponse(s)

04/01/2021

 Toyota Simon Morris (130Pts.)

0

Tundra G key 2010 Final program fail

2010 Tundrea with G key. Harness bought so no cutting/soldering of wires. I get to the final stage (this has been going on for weeks) and I connect the unit with the big white cable whilst holding the program button in. The lights flash as they should red/yellow/blue.I stop on red and blue. I then connect the 3 remaining cables larger white, smaller white and red. Press the program button twice and the red blue light flashes and never completes.IF I enter the key and turn the igntion on before pressing the progrsam button twice it DOES complete but then the truck cranks but does not start as it is still immobilsed. So have run out of ideas on this. Secondly I bought a flash link and had it sent to Asia where I live and this is now showing "limit reached"??This is service l number 002504 07557 for Evo One module serial number 002B04 015151. So can you help with the program problem and also reset my Flash Link. I am 12 hours ahead of Canada so "calling" cusstomer care from the other side of the world does not work. Thanks for any help you can give
Connectez-vous pour répondre Voir 1 réponse(s)

14/11/2020

 Toyota Juan Almonte (130Pts.)

0

toyota corolla 2010 dot key evo one crank but doens't start the engine

toyota corolla 2010 dot key evo one crank but doens't start the engine
Connectez-vous pour répondre Voir 1 réponse(s)

13/03/2019

 Toyota Thomas Frank (130Pts.)

0

2011 camry dot key cranks no start

I followed the instructions on guide and the car will crank with the remote starter but only runs while using the key
Connectez-vous pour répondre Voir 1 réponse(s)

13/10/2018

 Toyota Joe Callaco (380Pts.)

0

2014 RAV4 Cranks, but won’t start.

2014 RAV4. Using t harness, triple checked all connections. Programs successfully with a fast blue led blink, when switch to the run position. Updated to latest firmaware 79.49 with flash tool. Black key with H stamp. About 1 out 4 attempts, it will start perfectly in the 2nd try. If I insert the key, it works every time.
Connectez-vous pour répondre Voir 1 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer