English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

23/11/2016

 Nissan Daniel Waslenko (2650Pts.)

0

How to hook up auto light shutdown on 2011 Nissan Pathfinder with Intel key

I am using an EVO-ONE. I hooked the Dark blue from pin A8 to the driver door pin listed on wirecolor as the gray wire at pin 7 on the BCM in the white 15 pin plug. If that wire is hooked up the vehicle starts, then immediately shuts off. I left it disconnected until the customer comes back this Sunday so I can try to figure out what is going on. Remote start operates fine with it disconnected, but the lights do not shut off which will cause battery issues. I do not have the service number on hand. How do I hook up the wire to shut off the autolights? Is it possible that the gray is the wrong wire? Also on the wirecolor site it says the autolight shutdown wire is purple at the parking light harness but it is supposed to be cut. The install guide says to hook it up to the door pin.
Connectez-vous pour répondre Voir 1 réponse(s)

06/02/2016

 Nissan Jeff Tebbens (130Pts.)

0

'11 Nissan Quest PTS Evo T-Har. Stand Alone works BUT autolights stay on (despite door pin conn.) if EVO shuts car down

I am not a professional installer but am quite handy with wiring and installations of this sort. I installed the EVO-ALL with the T-Harness into my 2011 Nissan Quest (with Sliding Doors). I hooked up the 12V by splicing the wire behind the start button as instructed, as well as the parking lights and the door pin (which involved removing the entire dash and the instrument cluster. Here's the problem: When the car is started manually, with the lights in automatic mode (so they come on in the dark), they come on and everything behaves normally. When I go to shut the car off manually, it turns the auto headlights off after 30 seconds as it always has. All is good. However, if I start the car with the EVO, it turns the lights on (when in auto mode) as it it should (when it's dark or the sensor is covered), but if I turn the car OFF with the EVO, the lights stay on forever after the engine stops. They never turn off and would drain the battery overnight. Interestingly, if I turn the car off manually, it reverts to working properly, turning the headlights off after 30 seconds (a time I can set through a nissan feature). I tried to run this test in reverse - starting the car manually and shutting it off with the EVO, but the EVO does nothing to the car in this state. It must be programmed only to turn a car off that it has turned on. Is this correct? Anyhow, I'm trying to find a way to use my automatic lights and shut the car down with the EVO without worrying about a dead battery. Thanks, Jeff
Connectez-vous pour répondre Voir 1 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer