Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

How to hook up auto light shutdown on 2011 Nissan Pathfinder with Intel key

I am using an EVO-ONE. I hooked the Dark blue from pin A8 to the driver door pin listed on wirecolor as the gray wire at pin 7 on the BCM in the white 15 pin plug. If that wire is hooked up the vehicle starts, then immediately shuts off. I left it disconnected until the customer comes back this Sunday so I can try to figure out what is going on. Remote start operates fine with it disconnected, but the lights do not shut off which will cause battery issues. I do not have the service number on hand. How do I hook up the wire to shut off the autolights? Is it possible that the gray is the wrong wire? Also on the wirecolor site it says the autolight shutdown wire is purple at the parking light harness but it is supposed to be cut. The install guide says to hook it up to the door pin.

0

'11 Nissan Quest PTS Evo T-Har. Stand Alone works BUT autolights stay on (despite door pin conn.) if EVO shuts car down

I am not a professional installer but am quite handy with wiring and installations of this sort. I installed the EVO-ALL with the T-Harness into my 2011 Nissan Quest (with Sliding Doors). I hooked up the 12V by splicing the wire behind the start button as instructed, as well as the parking lights and the door pin (which involved removing the entire dash and the instrument cluster. Here's the problem: When the car is started manually, with the lights in automatic mode (so they come on in the dark), they come on and everything behaves normally. When I go to shut the car off manually, it turns the auto headlights off after 30 seconds as it always has. All is good. However, if I start the car with the EVO, it turns the lights on (when in auto mode) as it it should (when it's dark or the sensor is covered), but if I turn the car OFF with the EVO, the lights stay on forever after the engine stops. They never turn off and would drain the battery overnight. Interestingly, if I turn the car off manually, it reverts to working properly, turning the headlights off after 30 seconds (a time I can set through a nissan feature). I tried to run this test in reverse - starting the car manually and shutting it off with the EVO, but the EVO does nothing to the car in this state. It must be programmed only to turn a car off that it has turned on. Is this correct? Anyhow, I'm trying to find a way to use my automatic lights and shut the car down with the EVO without worrying about a dead battery. Thanks, Jeff

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue