I have a few quirks with my new install that I'm hoping to get answers for which I will bring up at the end, but first the installation so that the setup and configuration is known. I installed an EasyGO AM-F150 remote start and promity entry with push to start in my 2012 F150. I previously had an Evo-all setup for 3x remote start with the T-Harness. I reprogrammed the evo all for standard installation and killed the D1 for 3x remote start. I wired the new EasyGo system to the CanBus and Parking lights (+), then all other connections like the door sense, door lock, door unlock, parking light (-), and Ground while Running to the Evo-All. I connected the lock, unlock, and door pin wires from the Evo to the BCM as instructed (after testing for correct wires) The EasyGo also had a T-Harness so I just series it in with the T-Harness from the Evo-All.
Here is the behavior of the new EasyGO system:
The system locks the truck (only when doors are closed, otherwise does nothing). - Not a big deal
The system unlocks the truck (but after activating accessory mode for about 2 seconds) - A little annoying but may be necessary to disarm the oem alarm from what I understand
The system remote starts the vehicle (no adverse behavior) - All Good
The push to start button starts the vehicle (but whereas accessories activate, I can shift into gear and drive away, and the headlights turn on when in Drive; the auto headlights don't function and all the interior dash lighting for the radio and AC/Heater controls don't light up) - Biggest issue
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
