Good day,
I have the Evo-all chrt7 harness. I updated the firmware to 69.06 saved my settings, went to car followed the instructions perfectly, lights did what they should have done, ran the decryption said it was successful, plugged back in to car. It will not remote start. When standing outside looking in the window it says push brake then push to start? I did not install the hood pin since, the jeep already has 2 from the factory, I assume I did not need to. is there a setting Im missing? I have A11 off, A1 on A2 On, A3 On, A4 Off, A5 to A10 On, D1 On, C1 On, D4On, Data protocalls off. Please advise?
Thanks,
Kevin
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
