To start off with... the instructions were wrong, somebody at fortin assumed that a 2005 350z BCM is identical across all model years of 350z and that wasn't the case, I had a HUGE hassle trying to find the correct wires for my 2004 350z BCM but i believe with 99% accuracy i wired things correctly, now with this out of the way, after installing everything, programming the module, using the dcryptor, and even successfully programming the RF remote, it doesn't remote start.
it locks and unlocks fine with the RF remote, but when i click remote start, it sends the signal and the module receives it, and it blinks red telling me it couldn't remote start, in fact absolutely nothing happens. not even the ignition or accessories being turned on. i do have 2.3 enabled in the options which is the correct harness configuration. I don't understand why it doesn't remote start. it's like no power at all is being sent
does anybody have any idea why?
Also why does this guide below for the rf kit have used pins on the 20 pin connector, specifically "bypass ignition", "ignition" and "start"--
https://cdn02.fortin.ca/download/33021/rf642w-install-guide-33021.pdf
--that this guide below NOT have?
http://cdn02.fortin.ca/download/78221/evo-one_ig_thr_bi_nis-350z-xterra_key_a_78221.pdf
do those ignition and start wires from the 20 pin connector go somewhere? i tried grounding them, i tried leaving them unconnected, I tried wiring them to the ignition and starter wires on the 6-pin connector, and it never made a difference. someone please help.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
