Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

ُEvo One or Evo All, I don't know if the Evo All supports remote start on my car

Hello I have 2013 Honda Accord 2013 push to start and I would like to add remote start. Do I need Evo One or Evo all is enough? I will install the system with t-harnesses THAR-ONE-HON3 regards

0

2016 crv wont start after program

I went throught the installation, held button and plugged in then hit 3x then turned ignition on and waited for blue flash then ran decrypter and installed and the car will not start with 3x lock.... they sent me a new module and same thing. Am i doing something wrong?

0

no crank

hi, installed evo-one with t-harness in 2015 CRV two months ago... . Now only dash lights come on but doesnt crank. anything i can check thanks basic lock lock lock with no RF kit

0

Battery/awd icon light comes on after start. Need help

2012 crv fortune evo one with t harness. Everything works but I'm getting battery/awd icon light after start.

0

2007 Ridgeline X3 press not starting

Hey, installed my Evo - all on my 2007 Ridgeline. Programming process seemed to go fine. When I press lock 3 times the blue light blinks once, but truck doesn't start. I wire to wire installed it. The starter wire is in used in the wiring diagram not sure if I have to connect that?

0

2014 civic pts std with evo one with thar-hon3 will not enter reservation mode

Just installed a evo-one ( bybass firmware73.32 and .31 ) with hon3 t harness in a 2014 honda civic pts standard transmission, with all required settings enabled.( C1,D6,D2 and 2-2 and 38-2 ) I had set manual transmission ready mode for 33.2 and 33.1 after i programmed a rf kit . Unit programmed as it should, but the vehicle will not shut down after exiting the vehicle to complete ready mode. Also, the oem remote will not lock or unlock the car in this state. I had set the remote start sequence for lock 3x and also programmed a rf411 kit and same result, with the car not shutting off after exiting to complete reservation mode. Any ideas?

0

Fortin Evo One reservation mode disabling?

Installed an Evo one with the Tharness on my 2015 Honda Civic SI Sedan push to start 6speed manual shifter. Its all properly working with the OEM 3x lock remote start. Next is programming the rf kit but no luck on getting it to get recognized by the module. Next a day i am able to get to work it. Lock unlock trunk but not the remote start. On the keyfob indicating stop when trying to command the remote start. Now the OEM key fob don't remote start either. Also having an 3x flashing on my light. Ived read the manual of module and is says 3x parking light flashes means Ready mode disabled. How to fix it? Please help... SN 002B04 042049

0

Crank no start security key flashes

Crank no start 2013 honda accord push button start NON hybird. Security key flashes on dash while cranking. Cryptor maxium reached. S#002B04015344 push lock button 3x for remote start.

0

Evo all will not start Honda crosstour 2013

installed evo-all using t harness in 2013 honda crosstour pts. programming and decryptor worked perfectly. rerinstalled in veh and followed instructions. unit lights blue when lock/unlock button is pushed on key fob. 3x lock option did not work. reconfig unit to lock/unlock/lock. also did not work. unit lights up red then blue after attempt to remote start. yellow light does not come on like i have seen in how to and demo videos. i noticed in the wire color install instructions that the description does not mention the use of the t harness with the evo all only with the evo one. could this be an issue?

0

Unable to program the key

Hi, I want to reset because I am unable to copy the key slide

 

 

 

Exceeded the limit for this car

unit number

 

 

نموذج رقم الوحدة : EVO-ONE


SN: 002B04016358

 

0

2014 Honda Civic - Can I use Function 38 Mode 5 (38.5) Instead of Function 38 Mode 2 (38.2)?

I am going through the FlashLink Manager setup on my Evo One & THAR-ONE-HON3 and was curious if I can use 38.5 (Lock-Unlock-Lock to remote start) instead of using 38.2 (Lock x3 to remote start)? The vehicle specific manual says to use 38.2 but I would prefer to use 38.5. Is this possible?

0

2015 ACCORD PUSH TO START WONT START

I am asking this question again as the last answer simply asked for my number and I provided it and received nofurther assistance. I have made it successfully through all stages of installment. I repeat successfully through all stages of installment. The blue light flashes rapidly after the test to confirm my Can/Data/Immo connections are good. Also my hood is not open. Thanks for your assistance. This seems like a great product it just should have a troubleshooting guide for problems and how to fix them without going back and forth over the internet for days at a time. Thanks for all your help guys.001a06 886522

0

Honda Civic - Why wont the car turn off when lock button is pressed 3x?

Once I start the car (3x on the lock button) is there a way to turn the car off in a similar manner? Car will not turn off when the lock button is pressed 3 times as mentioned in other threads.

0

2018 Civic PTS, EVO ONE with T harness Crank but no start on 1st attempt, Lights flash 4 times

I programmed the module and hooked it up, Car remoted started fine. The 2nd time I tried to remote start after setting ready mode the car cranked but did not start (lights flash 4 times). After 10 seconds it attempted again and started. This has been going on for a week. sometimes it starts, sometimes on the 2nd attempt, sometimes not at all . Once, I couldnt shut the car off and had to disconnect the module in my work parking lot . I have reset and reprogrammed the module, Verified all T harness conections are tight and no bent pins and it does the same thing. I have emailed Tech support with no answer .

0

cannot lock the door or unlock the door when the evo one is activate

I have an Honda civic 2017 push to start manual. I have installed the evo one. i didnt connect the parking light to the car. i have programmed the evo one with the flash link for the version of my car at the moment, i think its the version 73.27 (if it can help i have installed the fortin evo one in november 2017) and didnt touch it after that. Also i dont use the T-harness i plugged every wire to the car directly like in the installation guide. My problem is : i can activate the remote start. but when i leave the vehicule and when i press my OEM remote to lock the door it does nothing, the car still running. i need to open the door and press the brake pedal to close the car. so i dont know why the door lock doesnt work. ive tried to buy the evo start to control my car with my cell phone. so i have installed the evo start in my car, i programmed everything and when i try to lock the door with the app it doesnt work too. i tried to start the car, but still do nothing. I did not plug the wire for the lock/unlock with the car (cause i dont really know which wire is it) and i dont know if its really my problem cause i read the can bus should do it. is anyone know what is my problem, cause i cant figure out what is the problem ? thanks in advance.

0

cannot lock the door or unlock the door when the evo one is activate

I have an Honda civic 2017 push to start manual. I have installed the evo one. i didnt connect the parking light to the car. i have programmed the evo one with the flash link for the version of my car at the moment, i think its the version 73.27 (if it can help i have installed the fortin evo one in november 2017) and didnt touch it after that. Also i dont use the T-harness i plugged every wire to the car directly like in the installation guide. My problem is : i can activate the remote start. but when i leave the vehicule and when i press my OEM remote to lock the door it does nothing, the car still running. i need to open the door and press the brake pedal to close the car. so i dont know why the door lock doesnt work. ive tried to buy the evo start to control my car with my cell phone. so i have installed the evo start in my car, i programmed everything and when i try to lock the door with the app it doesnt work too. i tried to start the car, but still do nothing. I did not plug the wire for the lock/unlock with the car (cause i dont really know which wire is it) and i dont know if its really my problem cause i read the can bus should do it. is anyone know what is my problem, cause i cant figure out what is the problem ? thanks in advance.

0

Unable to shut vehicle off with 3X lock remote start

2013 Honda Accord with PTS. Starts great, but unable to cancel during run time cycle.

0

Cut yellow loop wire for automatic

Hey everyone, I have installed multiple units, just notice the guide for 2013 Honda Accord push to start with the thar-one-hon3 did not state to cut the yellow wire loop. So I assumed I shouldn't cut it, like I always do for automatics. This would have saved me an hour of trouble leshooting why it would not remote start. Hopefully Fortin will update the guide to say cut the wire if automatic.

0

2009 Accord (manual trans) doesn't start unless I press the clutch

Hello, I tapped into the signal side of the clutch switch connector with a wire and connected it to the white wire on the 20 pin harness for an Evo One. If I take the clutch wire and connect it straight to the chassis ground the Evo One will start the car successfully, and it will also start successfully if I press the clutch with my foot while sitting in the car after setting ready mode. I did not connect the horn, parking lights, or the auto lights off wires to the car as I wanted to test everything beforehand. I also do not have a hood pin installed as it is apparently not needed for my car. Is there a wire for the unit I have to connect to ground or an option to enable? I tried to check the white wire to ground continuity while remote starting and it didnt seem to actually go low. But then again I don't have an amazing meter so I may be mistaken. Not using a relay or anything as the guide did not seem to call for one. Using an Evo One with a Hon5 t harness 2009 Honda Accord 4 cyl 2 door with manual trans Thank you Edit: Using the solid green wire for the clutch solved my issue.

0

2009 Accord (manual trans) doesn't start unless I press the clutch

Hello, I tapped into the signal side of the clutch switch connector with a wire and connected it to the white wire on the 20 pin harness for an Evo One. If I take the clutch wire and connect it straight to the chassis ground the Evo One will start the car successfully, and it will also start successfully if I press the clutch with my foot while sitting in the car after setting ready mode. I did not connect the horn, parking lights, or the auto lights off wires to the car as I wanted to test everything beforehand. I also do not have a hood pin installed as it is apparently not needed for my car. Is there a wire for the unit I have to connect to ground or an option to enable? I tried to check the white wire to ground continuity while remote starting and it didnt seem to actually go low. But then again I don't have an amazing meter so I may be mistaken. Not using a relay or anything as the guide did not seem to call for one. Using an Evo One with a Hon5 t harness 2009 Honda Accord 4 cyl 2 door with manual trans Thank you Edit: Using the solid green wire for the clutch solved my issue.

1

OEM Remote disabled after remote start via 3x Lock (EVO-ONE with T-Harness for 2014 Honda Odyssey)

After installing and configuring the EVO-ONE with T-Harness for our 2014 Honda Odyssey with Push to Start, everything is working properly, except that the OEM remotes become non-functional after starting via the "Push lock 3 times" method. Since we have not purchased a separate RF remote, the only eay to get into the car is if we leave a window open. Otherwise, we have to wait until the remote start time runs out, at which point the OEM remotes become operational again. The blue light on the EVO-ONE box does not light after remote starting the vehicle and remote buttons are pressed.

13/11/2016

Honda Josh F (160Pts.)

0

2013 Honda Civic: Location of Door Lock Harness?

Good day, I am stuck in my installation of an Evo-One unit in a 2013 Honda Civic with a Thar-One-Hon-2 harness. Everything has gone smoothly until I tried to locate the harness plug for the door locks (guide has it located as a blue 24-pin plug in the driver's door boot - vehicle has a factory alarm that must have the locks connected for a go-around) - this plug seemingly does not exist on this car! I've tried unplugging numerous other harnesses in the door boot area and trying the door locks - they keep working! The vehicle was manufactured 11/2013 - did Honda potentially update this plug on later models of the Civic? Thanks!

0

Honda CR-V 2010 Door lock/unlock

I have set all up according to the schema, engine starts, however doors don't lock/unlock. It's written in the manual that there's nothing else supposed to be done for doors lock/unlock. The OEM remote control works, because 3xlock switches the engine off. When the engine is started and the button is pressed on the OEM remote, the blue led is blinking on the evo-one.  

26/10/2015

Honda KOZ (750Pts.)

0

No 3x lock to start - 2015 CR-V smart key? or T-harness?

Are either of these in the works?

26/10/2015

Honda KOZ (750Pts.)

0

No 3x lock to start - 2015 CR-V smart key? or T-harness?

Are either of these in the works?

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer