Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

2010 Ford Escape Hybrid Door Pin Wire Location

I FINALLY found the 26 pin plug where the Green/Violet Driver Door Pin wire is located. It's in the driver kick panel. But it is all but impossible to get to. Really really really difficult as it is buried behind steel braces that cannot be removed. There is certainly not enough slack to get fingers in there to cut the wire and then attach the 2 separate wires needed. How do I accomplish this?

0

2012 Ford Fusion Hybrid Compatibility

I've purchased an Evo about a year ago, installed everything and could never get it to work. It would set off the alarm instead of starting. Unfortunately, I had to return it. I would like to try again but I cannot get a clear answer. Is the system even compatible with a 2012 Ford Fusion Hybrid? There is no mention of the Hybrid on the site, just the standard. I would like to get a clear answer and purchase it again if I find out it should for sure work.

0

Can EVO-ALL standalone be installed into a 2007 ford escape hybrid?

Guide 32171 (THAR-FOR1 THARNESS stand alone installation) indicates that the evo-all module can be installed into a ford escape hybrid vehicle. The evo-all module I have is programmed with C1, D1, D1.6, A5 off, program lock, and H2. It is not programmed with D4 though. Guide 34441 for stand alone installation shows that the D4 option is required for hybrid vehicle, which mine is). I have a T harness also with this module. Does the evo all module have to be programmed with option D4? Also, the lock/unlock input external controls are connected via a dashed line in guide 32171. Do these dashed lines indicate that they don't have to be connected as it is an option? Thanks for your help.

0

installer says that Key-override-all is defective

I had a rs-160-edp+ v-2.0 installed by a local insaller and he is telling me that the key-overide-all is causing my 2009 ford escape hybrid to resart and that it is defective and I need to replace it . The vehicle wil lsart but it stops runing after about ten seconds and then restarts.

0

tach wire for ford escape hybrid 2009 with ms sync

the wiring diagam shows pin 140 (ac/data)but on the ford escape hybrid 2009 with MS sync that wire is not there. what wire is the right wire for the tach?

0

Well is it normal for the evo not to turn on the ready to drive light on a fusion hybrid??

The dash lights up basically like with key in the ignition but the check engine light comes on and stays during the entire remote start sequence!! Never seems to go into full on?? During and I've already ran it through at least complete remote start cycles and still won't start engine!! Otherwise seems to be working fine!! The temperature here is around 40 degrees Fahrenheit today!! Again the ready to drive light doesn't come on at all during remote start!! This after 4 or 5 complete remote cycles!!

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer