English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

22/11/2019

 Ford Josh P (150Pts.)

0

No Brake command to evo all?

Hi I installed an evo all fort4 in a 2008 ford escape. Everything went well it starts the car with lock unlock lock. But the vehicle will stay running even after the foot brake is pressed. I noticed the brake wire is only an output on the evo all, so hooking this up to the foot brake didnt seem to work. The only way to shut the vehicle off is either wait for the timer to expire or push lock unlock lock again. Is there anyway to make the evo all recognize the foot brake? I was contamplating putting a relay from the positve brake wire to ground the hood pin control, but I would much prefer it to recognize over CAN bus if I can. Thanks!!
Connectez-vous pour répondre Voir 2 réponse(s)

15/12/2018

 Ford Kyle Riggio (130Pts.)

0

Brake applied when engine running, engine stops and doors lock seconds after

When the remote start system is active (engine running), if I enter the vehicle and step on the brake pedal, the engine stops (as it should) then the doors lock. Why do the doors lock?
Connectez-vous pour répondre Voir 1 réponse(s)

12/06/2017

 Ford Ross Ogans (200Pts.)

0

2010 Ford Taurus brake kill wire

I have atempted to figure out how to hook up the brake kill if needed to shut down the remote start. Have the Evo-All with the T harness. i have attempted to ground the dk blue wire to see if tha will inhibit the remote start from starting. With the dk blue wire grounded right to the battery it will still start. I was going to use this wire for my brake kill, but cannot seem to get that to work. What wire do I need to hook up for a bake kill and where. Thank you all in advanced!
Connectez-vous pour répondre Voir 1 réponse(s)

21/05/2017

 Ford Matthew Meiser (200Pts.)

0

Parking Light Connection causes Remote Start to shut down and the brake code flashes

2012 Escape Limited model, installed the EVO-ALL with the T-Harness. Parking light connection made to the purple/white wire in the door sill area per the recommendatiopn in the manual via a relay. When remote starting, the vehicle starts, then shuts down a couple seconds later and flashes the red LED twice to indicate brake on. With this connection broken, remote start works as intended.
Connectez-vous pour répondre Voir 2 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer