I have a 2008 Ford Escape automatic with standard key with the thar-for4 t harness and the evo all and I only have one key so I'm using the dcryptor and I programmed the module for standalone remote start and when I try to program the key to the module after I plug in the 4 pin black connector while the led is red I let go then plug in all remaining connectors, but when I plug in the red 6 pin connector the car starts and won't shut off until I unplug everything out of the evo-all, when I unplug just the 6 pin the car is sent into anti theft mode. Tried starting over and restarted the module and reprogrammed a few times and same result. What could be the issue? The first time I went through all the steps it was successful and the car would start and stop with the oem keyfob. Then I think I programmed something wrong and I can't get it back. The only was that I have hardwired is the yellow ignition wire and the dark blue hood pin wire.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
