I installed the Evo-All with the T-Harness into my 2016 Chrysler 200 (push-to-start) over the weekend. I did flash the unit beforehand with the options as indicated in the instruction manual and updated the software to the 74.[23] level recommended in the instructions. I did NOT connect the MUX wire to the parking lights, as I am not interested in the parking light functionality.
Programming and key decryption went entirely according to the book, and the vehicle remote-started immediately upon the initial test without difficulty. I have also integrated a Crimestopper Teleconnect into this installation, and the smartphone app starts the vehicle, shuts it off, and lock and unlocks the doors as expected.
However, I have a few issues and I'm hoping for some insight into remedying them:
1) The electronic driver display in the vehicle reads "Service Keyless System" immediately after the vehicle starts. This error clears after a few seconds, but remains resident in the vehicle's memory. This happens upon each start.
2) The vehicle will initially start and then shut off after a few seconds. Then it re-starts itself a few seconds later and runs for five minutes, and then shuts off. The options flashed to the Evo-All call for it to run for 15 minutes.
3) Attempts to re-start it are successful, but will run it for three minutes before it shuts off.
Obviously, I messed something up. Your insights are appreciated.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
