Hello, I tapped into the signal side of the clutch switch connector with a wire and connected it to the white wire on the 20 pin harness for an Evo One. If I take the clutch wire and connect it straight to the chassis ground the Evo One will start the car successfully, and it will also start successfully if I press the clutch with my foot while sitting in the car after setting ready mode.
I did not connect the horn, parking lights, or the auto lights off wires to the car as I wanted to test everything beforehand. I also do not have a hood pin installed as it is apparently not needed for my car. Is there a wire for the unit I have to connect to ground or an option to enable? I tried to check the white wire to ground continuity while remote starting and it didnt seem to actually go low. But then again I don't have an amazing meter so I may be mistaken. Not using a relay or anything as the guide did not seem to call for one.
Using an Evo One with a Hon5 t harness
2009 Honda Accord 4 cyl 2 door with manual trans
Thank you
Edit:
Using the solid green wire for the clutch solved my issue.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
