EVO-FORT1 for a 2014 Ford Focus SE (SFE) (Automatic Transmission) as a stand-alone installation (3x door lock start). I have the T-harness installed along with the connections to the Lt. Blue, Blue, and Yellow/Black wires on the harness. I have also connected the CAN bus signals. As I go through the 2-key programming sequence, the relay on the EVO-ALL will enable the ignition DURING the 3-second time of the 2nd key. When I remove the 2nd key and press/release the programming button, the unit never shuts off the ignition and neither the blue nor red LEDs flash. I have to remove power or the red connector from the EVO-ALL to turn off the ignition. I also tried pressing/releasing the foot brake as well.
During the programming sequence, I notice that the yellow LED will sometimes go on and then off. If I plug in the unit without putting it in programming mode, the unit will blink the blue LED if I press the door lock button.
I have been following guide #32051.
Does this indicate a problem with the unit itself, or is the pre-loaded firmware corrupt and needs to be re-programmed? (I will need to purchase a EVO Flash Link updater.) Is it a possible connection issue? Is it an issue in performing the programming sequence?
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
