I have ordered evo-all unit and connected it as stated at the guide Guide # 97611 page 5/13 (wire-to-wire). After I finished the connections and the programing, and finally connected the unit to the flashlike lite for CRYPTUR. Everything was going-on according to the steps in the guide without any problem. Then I connected the unit back to my car, and I remotly started my car by pressing the lock botton three times, and everthing was good until now, but then I noticed the following:
1- the secondary ligths and the tail ligths of the car become on even thought the ligth switch was on (off state), and the head lights never work when I dial the switch to the low beam and high beam state.
2-After I started the car remotely and I get inside the car and I press the push-to-start button of the car to shut the engin off, it shuts off then re-start again without any action from me, but if I open the door after that it shut the engin off.
3- If I press the lock button of the keyfob three times after I was started the car remotely, it shut engine off normally without re-starting again like what happened with me when I shut it off by the push-to-start button of the car.
4- I followed the wiring connection step by step, but I didn't connect only A1 and A16 wires to any where they still lose, do I need to connect them and where?
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
