Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

User

Erik Helsinger

Joined on the:

Feb. 10, 2016

Score

170

Comment(s)

1

Voted question(s)

0

Voted answer(s)

2

Votes up

0

Votes down

2

Votes up received

0

Votes down received

0

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

0

Need help with steps 4-6 programming EVO-ONE for 08 Hyundai Sonata

I purchased an EVO-ONE, RF-ALL-642W, Flashlink 2, and a THAR-ONE-KHY1 ignition T-harness and made the following connections to my US spec 2008 Hyundai Sonata. I have updated Bypass hardware version 2, firmware version 76.34 and Remote starter hardware version 7 firmware 1.21. Flashlink updater hardware version 4, firmware version 4.03 Cut loop for automatic transmission. Plugged 4 pin antenna wire to Blue connector of 4 pin data T-harness of RF-ALL-642W kit and plugged antenna to other end. I have connected the ignition T-harness at ignition pigtail, parallel soldered the 20 pin Yellow wire to the Pink wire of t-harness at EVO-ONE. Ignition T-harness Black wire ring and 4 pin data Black (added crimp ring) to known good dash ground. 4 pin Black data connector Red wire soldered parallel to Red wire of ignition T-harness. Soldered 20 pin Black parallel to Green wire at foot brake switch. Clipped Green PATS wire at driver kick - White connector (chassis) 20 pin Lt. Blue and 6 pin Red connector White/Green to harness side of Green wire at driver kick. 20 pin Lt. Blue/Black and 6 pin Red connector White/Red to connector side of Green wire at driver kick. 5 pin Grey/Black can low soldered parallel to Yellow wire at OBD-II 5 pin Gray can high soldered parallel to White wire at OBD-II When I hold the programming button down and plug in the 6 pin ignition T harness, Release programming button on Yellow and cycle the key from off to on, nothing happens, the light stays solid Yellow. I have confirmed that the yellow wire is getting 12v only on ignition hot. The car starts and runs with the key for several minutes, I switched the green clipped PATS wire connections and no change was observed. Searching the Q&A I found how to test the can bus by plugging the Black connector in while holding the programming button down, releasing on Blue, then plug the rest of the connectors (all of the ones listed above) in and turn the ignition on. When I do this the Blue light goes out. When I turn the key off, the Blue light comes back on. I have 1.89VDC and 2.27VDC on the can bus lines to a known good ground in the door jamb. Please help! Where do I go from here?

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue