2011 Chevy Cruze
Flash updater available? YES
Installed an EV0-All before? YES, Chrysler 300, Easy install, worked great.
THAR-GMv2 Wiring Harness
EVO-ALL HW version 6
Tried both firmware version 4.18 & 70.13
Connections made to EVO:
- red plug connector from GMv2 harness (6 wires)
- black data plug connector from GMv2 harness (4 wires)
- 5 pin white connector: 1 wire (brown) going to OBD2 port pin #1 (green wire)
- 20 pin white connector: 1 wire (brown/white) going to parking light connector wire (green/grey)
THAR-GMv2 harness has been plugged in and seated firmly
I am stuck on step 4 of programming. Once both red and yellow LED's turn on, I insert key and to run. I can't get the red LED to blink. I have tried a master reset, reflash of evo with different firmware version and nothing. Ithrough research i beleive the EVO is not detecting the ignition being turned on. Is this correct? What pin/connector can I test to confirm this? I also read the harness i am using may be a v1 and not a v2. Could this be? It says THAR-GM1 on a stciker attavched to the harness and another stciker is hand written that says V2. I thought that was a little wierd for it to be hand written. How can I confirm this is a V2?
Thanks for any input,
Chris
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
