Need help.
Problem 1: the car don't unlock. I hear the lock mechanism, but it's like if the car is locking instead of unlocking. The flashers flash twice. The lock command works fine (flashers flash once).
Problem 2: when I remote start the car, the alarm starts. I have to unlock the car from the oem remote to stop the alarm.
I installed an Evo One in a Mazda 3 2012 standard key using the regular installation instructions https://cdn02.fortin.ca/download/29661/evo-one_ig_reg_bi_maz-2-3-tribute_2001_key_b_29661.pdf
I connected all the wires directly, without any resistor.
The only wire I didn't connect is the "Parking Light" (E1).
The analog door lock wire (green/red A18) was connected to the dark green wire in the BCM driver kick panel (wirecolor pin 127,129) without any resistor.
All the firmwares are the latest.
Did I do something wrong?
Is it because of the parking light wire (White E1) that I didn't connect? I didn't find the wire on wirecolor. Is it accessory 2?
Is it because I didn't use the 1 Kohm resistor as on wirecolor for the analo door lock? How can I use a resistor for lock but not for unlock when using a single wire?
Do I have to activate/disable any option on the unit (evo one)?
Please help.
Thanks,
André
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
