Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

User

Alexey Kozlov

Joined on the:

Nov. 21, 2018

Score

430

Comment(s)

11

Voted question(s)

0

Voted answer(s)

3

Votes up

0

Votes down

3

Votes up received

0

Votes down received

0

Recent Activity

Question(s) asked

5

Answered question(s)

1

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question
RECENT ACTIVITY QUESTION(S) ASKED ANSWERED QUESTION(S) COMMENTED QUESTION(S)

07/10/2019

 Toyota Alexey Kozlov (430Pts.)

0

Wiring error in THAR-ONE-TOY9 with SIENNA 3rd gen.

A wiring error has been found in the low-current part of T-harness THAR-ONE-TOY9 (THAR-TY30 Rev. 1 LOT: 51096) when installing on Toyota Sienna LE 2019. The remote starter in/out wires for the AUTOLIGHT from EVO-ONE, pins A17 (Green/White) and A18 (Green/Red) are connected to a wrong pin of the Body ECU white 30-pin plug: they are connected to pin #6 instead of pin #28. This results in tripping a signal from the right rear (sliding) door trigger instead of the AUTOLIGHT signal. The problem applies to the installation of this T-harness on all 3rd gen. Siennas. The correct info on the Body ECU white 30 pin plug wiring can be found here: https://www.the12volt.com/installbay/printer_friendly_posts.asp?fid=3&tid=122207 To the contrast, the wiring diagram on the installation guide without this low-current T-harness is correct (Guide #72751), the AUTOLIGHT signal being taken from a different connector (on the steering column).
Login to reply View 1 answer(s)

04/10/2019

 Toyota Alexey Kozlov (430Pts.)

0

EVO-ONE does not control parking lights with headlight switch in AUTO position

Toyota Sienna LE 2019, EVO-ONE, THAR-ONE-TOY9, firmware version 79.[54]. EVO-ONE is configured with default/recommended options for my car. Everything is connected using T-harness per Installation Guide #72381. I have the following issue: EVO-ONE does not control the parking lights when the headlight switch is in AUTO position. The issue persists no matter whether it is day or night. So, I cannot read diagnostic codes by counting flashes in that position. Nevertheless, it does control the parking lights when the headlight switch is in DRL-OFF position. How can I fix that issue?
Login to reply View 0 answer(s)

03/10/2019

 Toyota Alexey Kozlov (430Pts.)

0

EVO-ONE flashes parking lights 30 times and remote lock command does not work

Toyota Sienna LE 2019, EVO-ONE, THAR-ONE-TOY9, RFALL642W, firmware version 79.[54]. EVO-ONE is configured with default/recommended options for my car. I have the following issue with EVO-ONE when I leave my headlight switch in DRL-OFF position and previously started my car remotely. When I open the door to leave my vehicle, my parking lights flash 30 times. In the Fortin manual, I found error code descriptions only up to 7 flashes. What is the meaning of that 30-times-flashing error code? In addition to that, the LOCK command from my RF kit has never worked but also makes the parking lights flash 30 times. So, I have to use my factory remote instead of the RF kit to lock my vehicle. The other commands from the RF kit (START, STOP, UNLOCK, SLIDING DOORS OPEN/CLOSE) are working fine. How can I fix that?
Login to reply View 3 answer(s)

03/10/2019

 Toyota Alexey Kozlov (430Pts.)

0

Sienna EVO-ONE pit-stop issue

Toyota Sienna LE 2019, EVO-ONE, THAR-ONE-TOY9, firmware version 79.[54]. EVO-ONE is configured with default/recommended options for my car. I have an issue with the pit-stop mode. I press 3xLOCK while inside the vehicle and engine running, then remove the key from the ignition lock. The engine continues to run but turns off when I open any door. How can I fix that issue?
Login to reply View 2 answer(s)

02/10/2019

 Toyota Alexey Kozlov (430Pts.)

0

Crimestopper RFALL642W does not work with EVO-ONE

I have connected Crimestopper RFALL642W to Fortin EVO-ONE installed on Toyota Sienna 2019 per Fortin manual https://cdn.fortin.ca/download/33021/rf642w-install-guide-33021.pdf. I have the following issue. When I connect the RF kit to the remote starter the blue LED on the RF kit antenna flashes one time. After that, when I try to program the remote transmitters per the same manual (turning ignition on and off, using the valet switch and brake pedal) I cannot get any antenna LED response. The LED on antenna always stays off and I cannot program the remote transmitters. In addition to that, the button on the RF kit antenna does not work when I try to use it as a valet switch per another Fortin manual. The RF kit is connected to EVO-ONE using a simple cable, not T-harness. EVO-ONE is configured with default/recommended options for my car. The firmware version is 79.[54]. The 3xLock start is enabled and working fine. Do I need to change any options on EVO-ONE so that it can communicate with the RF kit? Is my RF kit faulty?
Login to reply View 1 answer(s)

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue