Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

19/07/2019

 Toyota paolo fast (820Pts.)

0

Remote starter turns ignition on but engine is not ready

Hello i just installed evo-all on my toyota c.hr hybrid with t-harness, i m using this guide: https://fortin.ca/download/87601/evo-all_ig_tsa_bi_toy6-chr_2019_pts-hybrid_euro_a_87601.pdf When i press three times the lock button ignition goes on but the engine stays off, a/c goes on but the air is hot, the engine should crank but nothing happens, only the dashboard instrument of the car is on. The "ready" n the dashboard symbol that means the engine is ready to go is off, seems that the immobilizer has been not bypassed. I discovered also that the a16 wire even if connected or not doesn't change the result. engine doesn t start but ignition goes on.
Login to reply View 1 answer(s)

15/01/2019

 Toyota Sean S (190Pts.)

0

EVO-ONE Activates, but no Crank

Installing an EVO-ONE on a 2006 Toyota Solara, Automatic. Unit settings are as required (car is back with it's owner at the moment and I forgot to grab the service number), connections look solid and the automatic loop is cut. Programming seems to have worked fine, and lock/unlock/trunk release all work perfectly. I've doubled checked that the car was not in valet mode. Upon pressing remote start (using a Fortin brand RF kit), the parking lights light up and the red and yellow lights on the unit light up. The car seems to go to accessory or ignition mode, but right when it would be at the cranking point, nothing happens. I get 4 flashes (No Tach Signal?), then it retries with the same result. The No Tach Signal seems to be the issue here, but I'm not sure why. My only thought is regarding the wiring diagram on this car. As per the instructions, there are no wires going to the canbus lo/hi, could that be a problem? Or do the tx/rx wires of the installation cover that? EDIT: Other notes: The car starts fine without the remote start, and will still not crank even with the key in the ignition.
Login to reply View 0 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue