2017 Highlander Push to start EVO All standalone with Tharness & Evo start2 It Locks/Unlocks but DIDNT remotely start from Mobile.
I had evoall standalone with Tharness installed on the 2017 Toyota Highlander push to start working perfectly fine
Purchased a evo start2 with flash Link Updator 4
Removed the evo all module and update the firmare to latest
Save receommended options and save the options
Checked the Option C1,D1 H & H2 are on on the module
Try to decrypt thru decryptor, didnt succed
Installed EVostart 2 Antenna in the car windshield
NOTE: the antenna cable shown in installation guide is bit different from shown, have more connector and loose 4 cables red black yellow and green
Using Connection1 from evostart2 guide for EVO ALl standalone Installation
StepA:Connect 6 pin Antenna conector to Antenna
Step B: Connect 4 pin female blue connector to 4 pin male black connector from T harness
STep C: Connect Yellow wire from Antenna cable to Yellow wire going on A1 on 20pin white connector of T harness
Program EVO All with EVO start2 and got a green light. (programming successful)
Installed app on mobile and try to start,
When trying to start from MObile, the evostart2 gets a signal, shows blue light in atenna , but do nothing
I tried with OEM key fob for lock x3, it does nothing
Factory Reset the module, flash the module using flash Link Updator 4
Turn on c1 d1 and d6 h2
Program the module again and works with oem remote
Program the evo start2
Able to lock and Unlock, but not able to start from mobile
Troubleshooting:
I removed the yellow wire sttached to tharness
DONT KNOW WHAT HAPPENS WRONG
ALso checked grounding dark blue wire from 20 pin T harness to check if get red, NO D1 is enabled
please help
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
