Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

17/12/2015

 Mitsubishi jetskiman98 (140Pts.)

1

2012 Outlander Sport PTS will not start after installation

I installed an Evo-One (AX-One) in my wife's 2012 Outlander Sport. After after all the wiring was complete, I went to program the unit as per the directions only to find that vehicle will not start. It will not turn on. The car will not acknowledge the Push-To-Start button. Pressing the button only a yields a red back light, there are no other chimes and the display doesn't light up. I reconnected the CAN wires that were cut and the vehicle powers up and starts fine. I went back over the wiring diagram, tried again, and still had no sucess. Is there something that I could be missing? Has anyone else heard of this issue?
Login to reply View 1 answer(s)

25/11/2015

 Mitsubishi Saul G. (130Pts.)

0

EVO-ONE Ready mode issue 2008 Mitsubishi Eclipse / AUX Output

I have an Evo-One installed on a 2008 Mitsubishi Eclipse, Manual Transmission. The car is equipped with the factory alarm. I have function 32.5 (Ground out - Arm/Rearm) enabled as the installation guide states. It is connected to the Lt. Green driver door pin wire. However, after I put the car in “ready mode” when the car shuts off after I close the driver door and the pulse gets sent to the door pin (to arm/rearm factory alarm) it disables my “ready mode” as well. When I figured that out, I disconnected the (-GWR) wire from the door pin wire and the remote start works perfectly. Only thing is now the factory alarm doesn't arm after shut down of the remote start. Is there anything I can do? Or should I just keep that wire disconnected since everything else works fine. Also, what wire do I use to connect an AUX output? I’d like to wire in my rear defrost to activate when I press Aux 1 on my remote.
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue