Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

19/11/2021

 Mazda joel rowe (130Pts.)

0

Cx5 key handoff - shuts off on door being opened

Engine shuts off on door being opened. What setting needs to be changed to allow key handoff? 2016 Mazda CX5 I'm using evo-all with maz1 t harness. Thanx
Login to reply View 0 answer(s)

27/01/2021

 Mazda ERIC DOMINGO (290Pts.)

0

2010 Mazda 6 Standard Key EVO-ONE - Dcryptor Step 5

Hello, For a 2010 Mazda 6 Standard Key (instructions https://cdn02.fortin.ca/download/80571/evo-one_ig_reg_bi_maz_6_2009-2013_key_a_80571.pdf), I can't get the Dcryptor process (specifically step 5) to work for the EVO-ONE. The unit was removed and reinstalled, and I reflashed and master reset the bypass (Flashlink recommended 7.44 and I followed the hold down prog button while connecting 6-pin, then hold down again until all LEDs cycle). When I get to step 5, both the yellow and red LEDs are on and the red LED never turns off to proceed to step 6. If I turn off the ignition, both yellow and red remain on. I have tried the 2 key method and it will not work either. I have resoldered the TX and RX lines on the transponder connector as well. The unit otherwise attempts to remote start the car, but the security light flashes quickly on the dashboard and remote start is not successful, then the parking lights flash 4x after the failed start. Any other suggestions?
Login to reply View 1 answer(s)

23/01/2021

 Mazda Hovhannes Hakobyan (350Pts.)

0

message "invalid key data" during dcryptor step

message "invalid key data" during dcryptor step mazda 6 2014 start\stop
Login to reply View 1 answer(s)

12/12/2020

 Mazda Ryan Smith3 (130Pts.)

0

Blinking amber light on start button 2016 CX-5

The module seems to work fine, I have completed every step in the installation guide. However, the start button does continuously blink amber/orange while the vehicle is running and does not stop until the engine is shut down. This only happens when started normally, not remotely. If I disconnect power to the EVO ONE, the car can be started just fine and there is no blinking light. I used the THAR MAZ 3 t-harness to install. I have been scouring the Mazda forums and have found no answer. Everyone says either replace the fob batteries (I replaced them) or visit the dealer. The mazda dealer wanted $150 to diagnose the problem, and then doesn't want to even look at it after learning the Fortin system was installed. 

Login to reply View 1 answer(s)

15/05/2016

 Mazda Tu Tran2 (490Pts.)

1

2003 Mazda Tribute Evo One doesn't remote start without Key by the ignition

Hi, I'm installing an AX-One unit in a 2003 Mazda Tribute with revo-1 remotes. I'm using guide #16941, because I can't find CAN HIGH and LO. I got a1, a2,a3, a10,a11,a20, e2,e3,e4,e5,e6 connected. Programming and dcryptor went smooth. Got the revo-1 remotes programmed also. If I hold the key by the ignition the car will start. Without the key by the ingition the car won't start. I did noticed on Wirecolor.com a "Key sense" wire in the ignition harness. But I do not see where that connect to on the guide. Is that the wire I'm missing? Or is there something else? Thanks,
Login to reply View 1 answer(s)

19/01/2016

 Mazda Alexandre Pinard (130Pts.)

0

mazda 3 les portes debarre apres le demarrage avec loption 6 (lalarme ce declanche)

mazda 3 2012 les portes debarre apres le demarrage plutot que avant ( loption 6) donc l'alarme se declanche au demarrage puis quelques seconde plus tard les portes debarre et l'alarme cese que puis-je faire?
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue