Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

02/06/2023

 Mazda saber alzlfi (200Pts.)

0

DCRYPTOR'S LIMIT HAS BEEN REACHED FOR THIS CAR ON 2020 MAZDA 6

 have the OEM remote control then I have the EVO-ONE SN: 002B07 239663, THAR-ONE-MAZ3.

CAN YOU RESET  : EVO-ONE SN: 002B07 239663 

Please help and thank you.

Login to reply View 1 answer(s)

14/03/2021

 Mazda Martin Sermak (710Pts.)

0

Software Incompatibility with Remote Function Actuation

I have installed the EVO-ONE-942 with THAR-ONE-MAZ3 on my 2016 Mazda CX5 Automatic Push Start, and when scanning the vehicle with Thinkcar I get a DTC in EPS module, code U0338:00-08 (Software incompatibility with remote function actuation).

After clearing all code, it comes back again ...

Also, I've noticed the trunk open on the remote opens it half way, meaning it still cannot be actually opened until you unlock the car. Is there a way to disable trunk open as it doesn't work right?

Another weirs "issue" I found, when the car is unlocked with Fortin remote, then locked with "OEM" remote, when you check status with Fortin remote, it will say unlocked even though it's locked. Then when you lock with Fortin remote, it will report the status correctly.

 

Login to reply View 1 answer(s)

12/12/2020

 Mazda Ryan Smith3 (130Pts.)

0

Blinking amber light on start button 2016 CX-5

The module seems to work fine, I have completed every step in the installation guide. However, the start button does continuously blink amber/orange while the vehicle is running and does not stop until the engine is shut down. This only happens when started normally, not remotely. If I disconnect power to the EVO ONE, the car can be started just fine and there is no blinking light. I used the THAR MAZ 3 t-harness to install. I have been scouring the Mazda forums and have found no answer. Everyone says either replace the fob batteries (I replaced them) or visit the dealer. The mazda dealer wanted $150 to diagnose the problem, and then doesn't want to even look at it after learning the Fortin system was installed. 

Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue