Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

2018 Jeep Patriot Push to start auto remote start wont shut off passive error

I installed an all evo all in a 2018 jeep patriot push to start auto trans. Evo sn# 001a07 068469. Installed using sugested settings and current firmware that shows up in the desktop software. Vehicle starts fine with oem 3 lock but will not shut off with the oem 3 lock or after it should time out. Foot brake also does not seem to have any effect. Tried a reboot to factory and relearn security. Also occasionally getting a "service passive entry" on the dash.

0

2018 Jeep Cherokee push button start cruise comes on but won't set after install

0

Can you use a evo rs chrs5 on a 2008 jeep compass with a manual trans?

Looking to see if what I'm asking is possible or if it will ONLY work on automatic's.

0

2013 Jeep Compass will start remotely but will not turn off and has a transmission controller fault code. What is wrong?

2

Does the EVO-CHRT5 work with the Drone DR3400?

I have the EVO-CHRT5 remote starter installed on my 2015 Jeep Wrangler Unlimited. I want to add the Drone DR3400 to it so I can start the car from anywhere and keep an eye on the door locks and such when I have the top off. Is this compatable?

0

2014 Jeep Patriot Purpose of hood pin/valet, parking light, start/stop external connections

I am looking to Connect a Evo-All Stand Alone on a 2014 Jeep Patriot. I am following installation diagram C. When I bought this evo, it was preflashed and listed as only needing to connect the harnesses. I have not attempted any installation yet. For the single wire connection coming off the 20 pin connector, I am looking for more infomation on the purpose of them to determine what is necessary and to allow me to locate the wires and troubleshoot any incorrect connections. -For the 20 Pin Connector i. Externial input (Start/Stop External control negative) - What is this and what would this connect to? ii. Parking light out negative (this is the white/purple positive for 2014 jeep patriot) - Is this just to blink the break lights and would a relay be required to make this connection, if so is this connection necessary. If it is necessary would it connect to the red/purple wire (shown on wirecolor.com under parking lights) iii. Hood pin/Valet switch (no valet switch for 2014 Jeep Patriot which is a hatchback) is this a necessary connection and if so, where would this connect to near stearing column (without running under hood to actual switch). The directions state that this is optional, dark blue (from 20 pin connector) with no polarity given. Wirecolor.com list this as negative black/pink (from the 20 pin connector), and has no location or pictures of the colors. Yellow and Green/orange will be connected per instruction C. Seller Flashed for Stand Alone T Harness Hardware V6 Firmware Vr 74-19 (Seller may have updated it further) Date 11/2015

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue