Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

EVO-ALL Not Pairing With CAN BUS

Hello All;

I'm having difficulty getting the EVO-ALL to correctly pair with the CAN Bus.  Per the troubleshooting guide, I did double-check each connection and tested the voltage.  I believe I have an unbalance pair CAN1 connections.  One connductor tests at 4.5 and the other at .5.  Per the guide, I've tried to cycle the vechile thorugh its functions, e.g. Start, Stop, Seats, Mirrors, etc but I can't get the CAN1 conductors to measure at 2.5.  See troubleshooting guide below:

Any ideas?

Thanks!

 

NOTE: In some cases the can bus wires will fall into a single wire can system and this may prevent the module from programming the can bus. Meter the can bus wires one at a time. They should measure roughly 2.5 Volts DC per wire. If you have one wire with 4.5 Volts and the other is .5 Volts the module may not program. Stop programming and start the vehicle with the key or pts button, put the vehicle through its functions such as the radio on/off, door locks,electric seats, etc to try and balance out the can bus wires. In some cases you may need to drive the vehicle to get the Can Bus to balance back out. Once you have done this re test the can bus wires to ensure they are roughly 2.5 volts per wire.

0

2011 Hyundai Veracruz Limited Wiring Diagram wrong for 26 pin grey connector at BCM.

Your wiring diagram shows a grey 26 pin connector lower connector with Red (CAN HIGH1) and blue (CAN LOW1). The grey connector on the BCM on my car has orange for pin 1 and blue for pin 2 and only partially matches the picture for the rest of the grey connector. If connected properly should the fortin show flashing red and blue lights simultaneously after the 10 red flashes as directed in the program1 section or should it alternate? Richard

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue