Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

19/01/2016

 Infiniti SVL-RKM (130Pts.)

0

EX35 EVO-NIST1 and T-harness won't remote start without foot on brake

I have a 2008 Infiniti EX35 PTS with the EVO-NIST1 and T-harness installed for a standalone remote start system. I used the most current firmware, turned on D1 and C1 options, and the module was successfully programmed. The vehicle will not start with the 3x lock signal, it will only go to on and then acc modes. In troubleshooting, I pressed the brake pedal and then tried the 3x lock which started the car. Further, I tried switching the RL1 to RL2 connector, but this did not work. Next I put a voltmeter on the white/red wire on the brake connector harness, during the startup sequence the voltage seemed to be constant but only 11 volts and occationally dropped to 0 during the sequence. I re-installed the firmware and reprogrammed the EVO again to make sure there wasn't any issues, but it still work work. Do I have a bad EVO, harness, or something else?
Login to reply View 1 answer(s)

20/12/2013

 Infiniti Adam Mckay (430Pts.)

1

2008 Infiniti EX35, no crank

Im using an EVO-ALL with remote start. The unit powers up, but the push button only advances to ACC, almost like the white/black wire isn't triggering it to the IGN position. This makes it a little more wierd, If I hold the brake during remote start it WILL start but then dies after 5 seconds. Yes, I have checked that I am on the correct 12volt and Brake wire, and metered the brake wire during crank and it is being powered up similar to ignition or +GWR. I have checked through all my other connections all ready. Any input would be appreciated.
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue