2009 Kia Optima w/ Standard Key. EVO-ONE with T-Harness and latest Firmware. No PATS (No Immobilizer). Using Guide #60931 and Program #2 (Vehicle without PATS data wire).
I've tried everything, and cannot acquire the Can Bus data. Blue LED goes off instead of flashing rapidly when key is turned to the on/run position, and comes back on solid when the key is turn off.
I've double and triple-checked all wiring. All connections are soldered and pass continuity checks.
Yellow wire (A1) is connected to Pink wire (E5) on the T-Harness as shown in the Wiring Guide.
OBD-II connector Pin 6 (White wire) is connected to Gray wire (C3) and measures 2.7 VDC.
OBD-II connector Pin 14 (Black wire) is connected to Grey/Black wire (C4) and measures 2.3 VDC.
I reversed the connections to C3 and C4 with the same results: No flashing Blue LED.
Can anyone provide some guidance on what else to do to get this working?
Thank you.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
