I installed my Evo One with standard key. well i installed it and it wasn't working 100% meaning that some time it would work on the first try and not work until the second try, or even not at all. So i went back and checked and I may have found a loose starter (yellow) wire, but not 100% certain of that. Now Click the fob 3X, all the lights come on (dash, interior, parking) doors unlock, it seems to run its course. same as before but now does not start at all. Parking lights flash 4X indicating no tach. Then it cycles again with the same results but no start. I think the encryptor is now not working or had some issues to start with. with my power probe I have tested that everything else coming from the evo one is working. The ignition wire (pink) + comes on and then the starter wire (yellow) + comes on but the car will not start. I then tested the cars harness by unhooking the evo, then I put the key in the ignition in the on/run position, then use my power probe on the same wire that the yellow wire was plugged into, the car will start.
So then I'm thinking I should try and run through the install procedure with plugging in the 6 pin and running through the LED flashing light stop on Blue again procedure. This did not help any.
So, what is the best way to reset everything and try it again, or do you have something else I should check first,
Best Regards
Louis
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
