Thanks for your help in advance-Using EVO ALL in '14 Focus SE as stand alone remote start unit, with THAR-FORD1 T Harness.
Step one goes fine, led goes to solid blue (step 2) once data link connector inserted. Proceed to plug in all other connctors (step 3). All connectors go according to plan, until I plug in the 20 pin connector. Blue LED goes out and starts flashing......keeping me from going to step 4.
EDIT: CHANGED YELLOW TO IGNITION, WAS ABLE TO PROCEED AS INSTRUCTED.
CAN Hi/Lo are all connected at OBD connector, keys are factory keyless keys, with no markings-but I suspect they are the 40 bit keys as all the Focus' for '14 are. (I do not have the flash tool, I hope this doesn't hold me back!!)
Lock is connected to brown wire behind button on dash below radio.
Is the yellow that comes from the T-Harness to pin A1 in the 20 pin connector supposed to be ignition, or constant (+) ? It is constant as it is out of the box hooked to column connectors.
This is a brand new unit just received for this vehicle. It has firmware 71-18 , hardware version 6 , Service # 001A06448488
Thanks for any help getting this squared away.
Respects-
Justen
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
