EVO-ONE installed in a 2009 Lincoln MKZ in what I believe is called "stand alone" mode. Everything works as expected, 3x lock starts the car although I find 4x tends to work better, maybe just need to get the timing down to trigger the start.
When the car has been remotely started and I enter the car, I put the key in the ignition, turn it to the run position, and then step on the brake pedal to allow the car to be put into gear. When I step on the brake pedal the radio goes silent for about 2 or 3 seconds and returns. Is this the normal and expected behavior?
The installation guide #17373 was followed, I found that I did have to deviate for two items, the EVO-ONE would not recognize the brake pedal press via the CAN buss so I hooked up A11 to the brake switch and cut the yellow wire loop (it is an automatic). In addition I used the decryptor to program the system with a single key.
Thanks, J
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
