I used guide #17763 Rev. 20150121 on a 2010 Nissan Pathfinder with Intelli-Key. I did not make any connections for the parking lights as it is not shown in the guide. The parking lights are not coming on when I remote start with 3x lock. The install guide for the unit without the harness (#17233) shows connections and a relay for the parking lights. Do I have to install the relay and make the connections or are the lights controlled through CAN and just aren't working?
Also, in tesiting I have noticed that if someone is in the vehicle when it is remote started they can turn the tumbler to ON and drive away without unlocking any doors or having the Intelli-Key in or near the vehicle. I made the following connections to the tumbler:
white/red to red/blue - 12v
white/blue with diode to red/blue - key sense
another wire with a didoe spliced to white/blue before it's diode and going to red/white - tumbler sense
I am not having any problems with it locking up but was wondering if it is normal that the tumbler can be turned without the key being in the vehicle. Could it be a backward or faulty diode or have I made a mistake in the wiring?
One more note: the darkblue wire from the EVO that is to be connected to the doorpin wire for the autolight shutdown was causing the engine to shut down when the door was opened. I noticed that after a remote start the door open indicator was on then I cut the dark blue wire and that solved the problem. Function 32-2 was enabled as per the install guide. Not sure if this could be a wiring issue or an issue with the install guide or firmware.
Thanks for your help.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
