Utilisateur

Is there a problem with guide (34911 Rev. 2060914, 2014 Kuga PTS ATM, evo-all FW 71.35 and 71.44) or am I doing something wrong?

Problems begin from step 6:

2015 Ford Kuga PTS

Problem from 6 step of manual (34911):

6. "Press & release PTS to turn ON ignition, the YELLOW LED will turn on.The RED LED will turn OFF" - yellow lights up but red doesn't turns off

If I press start button several times (turn on/off ignition) - red finally turns off.

7. "Press & release PTS to turn OFF ignition, the YELLOW LED will turn off.The RED LED will turn ON" - the same again: yellow doesn't turn off and red doesn't turn on. I'm pressing again two or more times - yellow off, red on.

8. "Press & release PTS to turn ON ignition, The YELLOW LED will turn on and off.The RED LED will turn OFF. WAIT, the BLUE LED to flash rapidly"  - this time everything is ok.

9. "Press & release PTS to turn OFF ignition, The RED and YELLOW LEDs  will alternate." - OK again.

I'm disconnecting EVO-ALL, go to Dcryptor menu, sending data. After 2 minutes it says "The immobilizer data received from the module is incomplete".

I've tried several times on different firmwares (from minimum 71.35 and higher) - the same problem.

I installed my EVO All after updating and flashing the module the the newest firmware. The only issue is that the remote start does not work unless I am inside the car when I press the lock 3x on OEM key. When outside the car and I attempt to remote start, my dashboard will say that there is no key detected in the vehicle and therfore will not start. I quadruple checked the connection into the keyport and reset, reflashed and then reprogrammed the key several times with the updater software in bypass mode.  

I've discovered a temprary fix by leaving my spare fob in the car so I can remote start the vehice. The only issue is that someone could get in my car and drive off if my doors were to be left unlocked, and it defeats the purpose of a spare key.