so ive read most of the Q&A regarding this subject but i just want to confirm weather i need a resistor inline with the A5 wire for my van model or not? also do i need a diode inline before or after the resistor or does it not matter?
On a slightly off topic, when programming the key the module finished as planed so i pluged it back into the flashlink and it dcripted ok but when i went to follow the rest of the procedue for ready mode it was going as per the instructions until it asks to turn on the ignition and press the remote lock 3 times .... my remote wouldnt do anything i.e no lock sounds or any form of activity from the key fob buttons or the evo one then when i remove the key i remove the key the engine cuts out.
any ideas would be perfect
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
