Hi,
I had succesfully installed the EVO-ONE and using factory fob for remote start; The MyCar unit arrived with instructions. install-guide-64631. Everything works per instructions until step 8; when I press brake and release and then turn off, I get several blinks of lights and Evo unit, not the "Once" that is expected.
Mycar is online and I can see the unit, car voltage etc. It will just not learn to the EVO-ONE... I cannot seem to get past this step.
STEP 8. LEARN THE TELEMATICS DEVICE TO THE EVO-ONE
In order to communicate with the remote starter, the MyCar must be learned to the EVO-ONE.
1 - Cycle the ignition to the ON position.
2 - The YELLOW LED on top of the EVO-ONE should come ON.
3 - Press and Hold the EVO-ONE push button for 5 seconds.
4 - The parking lights and the RED LED on the side of the EVO-ONE will turn ON.
5 - Release the push button.
6 - Press and Release the push button 5x times. Everytime the push button is pressed the parking lights and the RED Led on the side of the EVO-ONE will blink.
7 - Then Press and Release the Brake pedal.
8 - Seconds later the RED LED on the side of the EVO-ONE will blink once to confirm that the MyCar ID has been learned to the EVO-ONE.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
