Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

15/11/2024

Toyota Pavlo (130Pts.)

0

Corolla 2005 guide#84861 advice to install 79(65) min firmware, Flash link advice to install 79(59)

Corolla 2005 guide#84861 advice to install 79(65) min firmware, Flash link advice to install 79(59). What firmware I need to install? Would you able to describe for me 32.3(Dk blue (GWR) shut down after ) ?How it works? I have just one dark blue wire A8 from evo-one for the driver door pin. Is it mandatory to connect this wire? Thank you.

0

2020 Toyota Corolla THAR-TOY13 Install Guide ?

Does anyone know-where or has step by step instructions on where the connect the harness within the car? I find this video online but the quality's a bit crappy... https://www.youtube.com/watch?v=wXubJ6NOrGs&list=WL&index=1&t=25s Anything helps... Pls and Thanks

0

Need help EVO-TOYT13 wont start, multiple attempts at programming 2020 Toyota Corolla

After multiple failed attempts at programming and Dcryption (all failed) I came to the Q&A section, see many issues on 2020 Corollas so I saw a response to do a master reset and start over. I factory reset the unit only to get an error message after the reset. "The current device cannot be flashed anymore." Serial number: 001A07 252153

0

Evo all with Start 2 For Corolla 2022 Push Start

I havs install evo all with start 2 for mobile support. The module is programmed when i press lock key on remote the blue led indicates with each click and after red led turned on same is with remote start app but my car is not starting. is anyone here help me to troubleshoot pls?

0

False confirmation from RFK942 remote

Recently installed an evo all and the RFK 942 in my 2021 Corolla. The OEM key fob works fine when remote starting (lock, unlock, lock), but its not the same for the RF kit. When I press and hold the start button it beeps and flashes green indicating a successful start, however the car doesn’t actually start. When I try it for the second or third time that's when it starts. I am just at my window about 10 meters away from the vehicle. Anyone else have this problem?

0

EVO ONE 2017 COROLLA H KEY HVAC

HVAC WORKS ONLY DURING TAKE OVER. IS THIS NORMAL OPERATION? EVERY EVO IVE INSTALLED, THE HVAC OPERATES. SO BASICALLY CAR WONT BE WARM UNTILL THE CAR IS TAKEN OVER AND HVAC CONTROLS OPERATE.

05/12/2022

Toyota G M (14940Pts.)

0

Toyota Corolla 2017 Evo-One

Hello. I want to install Evo-One (002B04295703) on 2017 Toyota Corolla (Euro). I tried 3 different programs and none of them worked. When the red and blue lights flash 9 times, I turn ignition ON and the red and blue lights go out. nothing more. I took the CANs from the OBD (it didn't work with the steering wheel). If I turn ignition ON to blue , the CANs are programmed, and the engine starts with 3 clicks if we put the chip near the antenna. IMO probably not readable from OBD. I connected it from the engine module, but it did nothing. what do you recommend?

0

2016 Toyota Corolla Automatic Headlights

2016 Toyota Corolla, H-Key, Manual. No OEM Alarm, No TPMS (and no wire for TPMS, no wire to pin location on plug). Installed EVO-One with Toy-8 and RFK942. Setup via wizard. Only wire T'd was for clutch bypass.

Completed a recent install but have a couple of issues I am hoping to resolve.

1) Automatic headlights won't turn off when setting reservation mode. Tried on door close, and also on lock. Believe it needs a door pin pulse which is connected via the harness. Is there a setting I am missing somewhere?

 

2) Once the Evo was installed, neither of my factory fobs work (even when not remote started). Unplugged the Evo (but left harness) and still no fobs work. Nothing lights up on the evo when pressing factory fob.

 ***Update***: Found a bent pin in my T-Harness when troubleshooting. I was able to straighten it back out, all fobs are working again. Stil have the issue with the headlights.

Thanks all for the help

0

Where to connect the Yellow wire on the Evo start 2. Using EVO one and THAR TOY 8

Using the THAR TOY 8 and EVO ONE, wanted some clarification on where to connect the yellow wire from the EVO Start 2.

0

EVO-ALL-411 VS EVO-ONE-411

I WOULD LIKE TO KNOW THE EVO-ALL-411 VS EVO-ONE-411 COMPARISON   According to the site, the 2 are compatible on a TOYOTA COROLLA 2019 HACHBACK, PUSH TO START   Apart from the price what are the advantages / disadvantages between the 2 ???         J'AIMERAIS CONNAITRE LE COMPARATIF EVO-ALL-411 VS EVO-ONE-411   Selon le site, les 2 sont compatibles sur une TOYOTA COROLLA 2019 HACHBACK, PUSH TO START   A part le prix quels sont les avantages / inconvénient entre les 2 ???

 

0

Toyota Corolla has no central locking system but has electric door locks, can lock and unlock be added?

2006 Toyota Corolla doesn't have a central locking system but it does have elcetric door locks, is there a way to use the EVO ONE to control lock and unlock? The cables are diffrent then what is shown in "Color wire", color wire says there are two cables in a blue connector, one for unlock and one for lock but mine doesnt have those cables. I found a Toyota Bullitin for adding an oem central locking and it talks about a red wire in the same blue connector that has to be inturrupted but controls both lock and unlock. Thanks

0

Toyota Corolla has no central locking system but has electric door locks, can lock and unlock be added?

2006 Toyota Corolla doesn't have a central locking system but it does have elcetric door locks, is there a way to use the EVO ONE to control lock and unlock? The cables are diffrent then what is shown in "Color wire", color wire says there are two cables in a blue connector, one for unlock and one for lock but mine doesnt have those cables. I found a Toyota Bullitin for adding an oem central locking and it talks about a red wire in the same blue connector that has to be inturrupted but controls both lock and unlock. Thanks

0

2006 Toyota corolla no start

2006 toyota corolla followed install guide module is programed and responses when key is asked to insert in guide flashes 10 times fast light goes off but does not responed when locked 3 times ive uploaded the module several times have done this many times on other cars with zero issues ..... when the ground while running is attached the red light will stay on and not go off

0

toyota corolla 2010 dot key evo one crank but doens't start the engine

toyota corolla 2010 dot key evo one crank but doens't start the engine

0

2016 Toyota Corolla Evo One

I have used the Toy 8 Harness that came with the Evo One,Module (TOY 8 79/xx/1.xx C1, D5 38.2 Progam Lock). I followed all the steps and when I plug the 20 Pin Connector in the Evo Module, the noise sounds and the dash board warning message says, TURN LIGHS OFF and when I try to Press the button 10 times, the RED and BLUE LEDs fade out by the time I get to 6. I can't get Pass Step 3! I reset it a few times and still the same thing! I switch the Pins and try to use it as a TOY 3 Harness and the same Thing! I even Hard Wired the module using the Diagram and still the same thing! I'm thinking this was a bad Module from the beginnig! I have listen to TECH Support ideas and tried them and nothing works! I've made 7 attempts on wire this Evo One, trying different ways and the Module keeps doing the same thing every time. I'm ready to give up! Any idea, why this Warning Light coming on? Do this warning light be the reason why I can't ger pass Step 3?

0

2016 Toyota Corolla with H key,

After following the diagram and I go through the steps! When I go to plug the 20 Pin connector in the EVO ONE, it makes a noise like the lights are left on and the Dash Board warning say's TURN LIGHTS OFF! When I unplug the 20 Pin connector, the noise goes awayand the dash bord warning for TURN LIGHTS OFF, goes away! I try to program the EVO ONE Module with the noise and TURN LIGHTS OFF, by pressing 10 times, the light stop around the 5th to 6th press and it won't let me get pass Step 3. I reset the Module and did and Master rest and still have the same problem!

0

2016 Toyota Corolla with H key,

After following the diagram and I go through the steps! When I go to plug the 20 Pin connector in the EVO ONE, it makes a noise like the lights are left on and the Dash Board warning say's TURN LIGHTS OFF! When I unplug the 20 Pin connector, the noise goes awayand the dash bord warning for TURN LIGHTS OFF, goes away! I try to program the EVO ONE Module with the noise and TURN LIGHTS OFF, by pressing 10 times, the light stop around the 5th to 6th press and it won't let me get pass Step 3. I reset the Module and did and Master rest and still have the same problem!

0

I have a Toyota Corolla 2014 Standard 1.6 Liter... What do I choose?

I have a Toyota Corolla 2014 Standard 1.6 Liter... What do I choose?

0

Request: Pin or socket photos of THAR TOY-13

I'm installing an EVO-ALL into a 2019 Corolla Hatchback using a TOY-13 harness.  The harness is labeled TY70, and the connections to the factory ECU harness in the driver-side floorboard have different plug shapes.

If someone has a THAR TOY-13 and can take a photo of harness connectors that plug in between the blue and white/gray sockets, I would appreciate it.  Either the box I received was mislabeled, or Fortin's website is wrong.

(post as answer with photos or links to photo hosting site, please)

Thank you!

0

Request: Pin or socket photos of THAR TOY-13

I'm installing an EVO-ALL into a 2019 Corolla Hatchback using a TOY-13 harness.  The harness is labeled TY70, and the connections to the factory ECU harness in the driver-side floorboard have different plug shapes.

If someone has a THAR TOY-13 and can take a photo of harness connectors that plug in between the blue and white/gray sockets, I would appreciate it.  Either the box I received was mislabeled, or Fortin's website is wrong.

(post as answer with photos or links to photo hosting site, please)

Thank you!

0

Compustar pro g15, evo one and 2008 Toyota Corolla dot key

Wondering if the compustar pro g15 is compatible with the 2008 Toyota Corolla, using the evo one

0

3x remote start not working 2015 toyota corrola h key

the evo one 3x remote start feature does not work it programs correctly but when i hit the lock button all i get is the blue light to flash when button hit i have gone in and turnede on option c1 and d5 as in the instruction still can not get to start

0

Toyota corolla 2014 module programmer mais ne fonctionne pas

Mon module est programmé mais l’antenne ne s’allume pas clé on et les parking light ne s’allume ps en appuyant sur le bouton? La seule facon que la lumiere de l’antenne allume est en démarrant la voiture lorsque le moteur tourne mais pas démarré la lumiere de l’antenne clignote mon module est un evo one sans t harness et mon corolla avec h-key

1

2013 g key corolla evo one no start

Ive installed evo one on a 2013 corolla g key manual transmission. the door locks and trunk work with the fortin remotes. when i hit the remote start button the lights turn on like it wants to start but the moteur doesnt actually turn over. then it flashes 4x as if to say there is no tachometer signal. also worth mentioning that ive had to enable the ready mode a few times. ive checked my wiring and it all seems ok. what can i do.

0

Is adding rf kit 642w a straight plug and play connection to evo one or i have to solder some additional wire ?

adding fortin 642w rf kit 2010 corolla AT w/ dot key with evo one module

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer