Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

EVO-One and Viper VSM550 2020 Toyota Tacoma H-Key

2020 Toyota Tacoma Auto, No factory alarm, H Key. Evo-One No RF kits Viper VSM550 Cellular Tried following the guides, remote start works fine, but the vsm550 did not have a green light and would not communcate with the evo-one. May have used the wrong remote start side firmware at first, i used the "recommended firmware" that flashlink told me. I think 1.25 Used the latest Bypass firmware flashlink recommended, cant remember at the moment what it was. Installed the unit with the t harnesses, made the tmps cut etc, all seemed to work as it should, realized the cell was not working, so i pulled the unit to bring inside and was going to drop it down to 0.83 which i did. However when i went to check the options for the rf kit, xl202 option was missing but checked, it show N/A along with several other options that way. Tried to flash to a different firmware and back, even tried uninstalling flash link and reinstall, didnt work. decided to flash it to my honda pilot and then go back to my tacoma but apparently at this point i am told i can no longer flash the unit. That being said, i can now see the option for xl202 again, note the option was there when i first flashed it all and took to the truck, it was only gone when i tried to drop down to .83 My main question now is: 1. can someone please unlock my unit so i can flash it back to my truck. - 002B04 008976 2. what is the correct combination of firmwares / latest firmwares for my setup, bypass side and remote start side.

0

MyCar Programming without valet switch

How do I enter programming mode to get the MyCar module programmed without a valet switch? I have a 2013 Toyota Tundra and installed the Evo One in 2015. Everything works fine. I'm unable to get the Evo One into programming mode to accept the MyCar Telematics module (because I never had a valet switch). Is there any other way to get into programming mode without a valet switch?

0

MyCar Telematics starts then turns off after a few seconds

Vehicle: 2011 Toyota Corolla S (G-Key), manufactured in CAN.

Evo-One w/T-harness installed and working properly using OEM remote (3x lock to start).

 

When trying to start vehicle via the MyCar app, the engine will start and as soon as the doors auto lock the engine will shut off.

 

I have installed the MyCar Controls telematics unit based on the guide here: http://cdn02.fortin.ca/download/64631/autolink-install-guide-64631.pdf#page9

I used the HRN-LLRS-01 connector as instructed.

“Fortin 2” selected in RF section of configuration tab in FlashLink Manager.

MyCar Controls app Device Protocol: Fortin

 

Please help!

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer