English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

08/11/2022

 Toyota Scott Chalupnik (170Pts.)

1

2020 Tundra OEM alarm orange wire spliced in?

Hard to tell from install guide. For OEM alarm, does the orange wire need to be spliced into the wire? Does it matter whether it is spliced into the original plug or the T-harness?
Connectez-vous pour répondre Voir 1 réponse(s)

28/12/2021

 Toyota John Pepper (180Pts.)

0

2019 4Runner alarm going off during remote start

Installed the EVO-ONE/TOY-9/RFK441 into a 2019 standard key 4Runner. Not every start, but most starts are followed by the alarm going off. It's keeping the customer from using the starter out of anxiety. Any ideas? Did I program the EVO wrong? Did I program the RFK441 remotes wrong?
Connectez-vous pour répondre Voir 1 réponse(s)

29/10/2021

 Toyota Eric Bridgemohansingh (160Pts.)

0

Evo start with analog install on Evo one?

I was looking to install Evo one starter with alarm with Evo start on my 98 4runner I know my vehicle is not listed but with analog installation of Evo one this should work no problem I just wanted to know if the Evo start is able to work with a analog system and if I can still add an aftermarket RF kit like the compustar G15 RF kit?
Connectez-vous pour répondre Voir 1 réponse(s)

01/09/2021

 Toyota Mike Stanko (220Pts.)

0

Disarming Fortin alarm function with OEM remote on 2011 Camry

Fortin EVO-ONE installed into a 2011 Toyota Camry. Firmware 1.[25] loaded. Fortin alarm function has been enabled. Alarm works as expected when using the Fortin RF remote. However, if the OEM remote is used to unlock the vehicle, the alarm will sound when the door is opened. Can the OEM remote be configured to disarm the alarm? Option C1 OEM Remote Monitoring is enabled.
Connectez-vous pour répondre Voir 1 réponse(s)

24/08/2021

 Toyota levi veress (130Pts.)

0

2007 toyota tundra evo-one install with fortin remote sets off alarm at remote start

Alarm worked fine for a couple of days after the install. Now 3 times out of 5 it triggers the oem alarm when trying to remote start. I checked the light green wire(disarm) and it seemed to get good connection.
Connectez-vous pour répondre Voir 1 réponse(s)

13/03/2021

 Toyota Christopher Wilson (200Pts.)

1

2018 Tundra, OEM alarm connection (orange wire)?

Nevermind. I figured it out.
Connectez-vous pour répondre Voir 0 réponse(s)

01/02/2020

 Toyota robert ball (130Pts.)

0

No sound when alarm is activated (2013 Rav4 EVO-ALL with t-harness)

I installed the EVO-ALL on a 2013 Rav 4 with push to start using the TOY6 t-harness. I made no connections other than the plug-in connectors (guide 70391). The t-harness includes a wire on A4 - this is the wire I used for a horn on my one other install (guide 12971). Remote start works & the parking lights flash when the alarm is triggered, but there is no audible alarm. If I adjust G1 to horn instead of siren, the door locks are activated alternately as the horn would be when the alarm is triggered. Guide 8821 shows A4 is 'door status' for this car so maybe this makes sense. What do I need to change to allow for an audible alarm? Thanks!
Connectez-vous pour répondre Voir 0 réponse(s)

29/07/2019

 Toyota paolo fast (820Pts.)

0

Siren alarm ok but no chirp confirmation

Hello Evo-all with toyota c-hr 2017 hybrid. I used this guide to install it : https://fortin.ca/download/87601/evo-all_ig_tsa_bi_toy6-chr_2019_pts-hybrid_euro_a_87601.pdf Evrything works cool. Today i installed a siren too, using this guide https://cdn02.fortin.ca/en/download/16221/16221.pdf I have turn on option G and Evo alarm. Indeed siren works when i open the door from inside but i have not confirmation chirps on lock / unlock. could u help me? Thanks.
Connectez-vous pour répondre Voir 1 réponse(s)

01/02/2019

 Toyota Michael LaCaze (310Pts.)

0

2019 Tundra Evo-One with OEM alarm system operation

What is the alarm priority when using an Evo-One with the Toyota factory alarm? From what I can tell when locking the truck the Evo just arms the OEM system but does not appear to trigger any alarms itself. Of course it does function as a remote start system but I am not sure that it adds any alarm functionality in this configuration. Currently I have not connected a siren to the alarm but I am guessing that all that will do is to sound the siren when the shock sensor is acitvated. Exactly how does the Evo work in this confirguration?
Connectez-vous pour répondre Voir 1 réponse(s)

18/12/2018

 Toyota Tyler Block (130Pts.)

0

Evo One 2018 tundra: Intermittent start on 3x lock, and alarm goes off occasionally

I just installed an EVO one for my 2018 Tundra with Toy10 T harness setup, preprogrammed. The 3x lock button starts the truck intermittently. Is there a specific cadence to it? Also, the alarm goes off occasionally when it remote starts after 3x lock. Any ideas?
Connectez-vous pour répondre Voir 0 réponse(s)

26/06/2018

 Toyota Juan L Amezcua (250Pts.)

0

Installed but nothing happened no alarm and remote start works

I did the install as recommend for 2008 Toyota Corolla don't key, ( connection 1 , program 1) manage to program the evo one I used the OEM controls and nothing happened, no alarm working remote start not working either
Connectez-vous pour répondre Voir 1 réponse(s)

19/04/2018

 Toyota Juan L Amezcua (250Pts.)

0

How to use Evo one as stand alone alarm

Want to know how to connect evo one as stand alone alarm, my car doesn't have alarm, and also how to use the available censors on my car and how to add other sensors like impact censor and windows censor
Connectez-vous pour répondre Voir 1 réponse(s)

06/10/2016

 Toyota Ashlee Hobbs (130Pts.)

0

2014 Tundra alarm goes off when 3x lock to start with Evo-One.

The truck starts but when it does the alarm goes off. When it does this, it disables factory remote and you have to use the key to unlock the door. Also, all of the dash lights come on and stay on until you kill the engine and restart. Installed 9 months ago and has been working fine until now.
Connectez-vous pour répondre Voir 3 réponse(s)

29/01/2017

 Toyota Jim (850Pts.)

0

Can EVO-ALL be used as an alarm for a 2001 Tacoma and if so what guide.

I am wanting to use the EVO-ALL in a 2001 Toyota Tacoma as an alarm with an external RF Antenna to control the door locks and an Avital 4113 remote starter I plan to integrate with it. The vehicle does not have an alarm or remote natively with it. The Avital remote start will be hard wired to the EVO-ALL since I am using an RF kit. The question is what guide and what firmware should I use for the unit to make this is possible. Thank you.
Connectez-vous pour répondre Voir 1 réponse(s)

14/01/2017

 Toyota Jack Fucili (130Pts.)

0

Fortin install manual is for immobilzed ignition 2002 4runner need install for non immobiled ignition

Installing an EVO One serial # 002B07 156139 on a 2002 Toyota 4runner that does not have the transponder key. Install from your site only shows the install for a transponder key install. I need to know what the difference in install would be (IE wires to be hooked up and to what). Thanks for your help.
Connectez-vous pour répondre Voir 0 réponse(s)

06/10/2016

 Toyota Ashlee Hobbs (130Pts.)

0

2014 Tundra alarm goes off when 3x lock to start with Evo-One.

The truck starts but when it does the alarm goes off. When it does this, it disables factory remote and you have to use the key to unlock the door. Also, all of the dash lights come on and stay on until you kill the engine and restart. Installed 9 months ago and has been working fine until now.
Connectez-vous pour répondre Voir 3 réponse(s)

06/10/2016

 Toyota Ashlee Hobbs (130Pts.)

0

2014 Tundra alarm goes off when 3x lock to start with Evo-One.

The truck starts but when it does the alarm goes off. When it does this, it disables factory remote and you have to use the key to unlock the door. Also, all of the dash lights come on and stay on until you kill the engine and restart. Installed 9 months ago and has been working fine until now.
Connectez-vous pour répondre Voir 3 réponse(s)

03/05/2016

 Toyota Danny Rivera (510Pts.)

1

Programming the EVO ALL just for the alarm function

I followed the guide 16221.pdf to make the connections for my car (a 5 speed Toyota Yaris 2012) according to the pages 10 and 11, aso connected the CAN high and low. Flashed the module in connection mode Bypass just with the alarm options ON, no remote start and immobiliser (my car doesnt have one, not IMMO data in the OBDII plug). When I tried the programming, guide 29771: 1.Insert datalink, hold the button, release when leds blue and red are on 2. Connect the rest of the cables (20 pin and CAN), press the programming button twice. 3.Blue and red leds flash, turned the key to the ON position. 4. The red led just keep flashing, the blue one never turn on, I did the CAN check and connections are OK I appreciate any help
Connectez-vous pour répondre Voir 1 réponse(s)

30/12/2015

 Toyota Danny Rivera (510Pts.)

0

Dash led - EVO ALL as a alarm system

The EVO-ALL has many input and outputs (lights, sensors, switches) but i was thinking in a way to power a dash LED to indicate the status of the built-in alarm.
Connectez-vous pour répondre Voir 1 réponse(s)

11/11/2015

 Toyota Sung Kim (350Pts.)

0

2014 Tundra factory alarm goes off when opening door time to time

I have 2014 Toyota Tundra with EVO-ONE w/ remote start working just fine. Also, factory alarm is enabled on the vehicle. Time to time, when I unlock the car with remote and open the door, factory alarm will go off. It is not every time but may be 1 out of 10 times. When the alarm goes off, I just click the unlock button again, it stops. Do you know what may cause this issue?
Connectez-vous pour répondre Voir 2 réponse(s)

13/01/2016

 Toyota Brian Eaton (180Pts.)

1

2015 Highlander Autolight and factory disarm issues

We are installing an Avital 5303 with an EVO ALL module. When the vehicle is remote started, it works great, but the factory alarm honks while the vehicle is preparing to remote start and then stops, obviously due to ignition and smart key = factory disarm. Even with D2 programmed on the EVO ALL, it does not stop this. If I use the factory alarm disarm wire during remote start, the vehicle unlocks and remains unlocked. I guess I will have to hardwire the factory alarm disarm wire, even though the EVO instructions say that this issue will be corrected by enabling D2. In addition, the customer always leaves their auto lights on. If you shut down the remote start, the lights stay on indefinitely, until a door is opened and closed. Does anyone know how to correct this?
Connectez-vous pour répondre Voir 1 réponse(s)

09/12/2015

 Toyota Tu Tran2 (490Pts.)

0

Alarm goes off when start vehicle in the morning

Currently I have option 14.2 (I think). If i select option 14.1 will this stop the problem?
Connectez-vous pour répondre Voir 1 réponse(s)

11/11/2015

 Toyota Sung Kim (350Pts.)

0

2014 Tundra factory alarm goes off when opening door time to time

I have 2014 Toyota Tundra with EVO-ONE w/ remote start working just fine. Also, factory alarm is enabled on the vehicle. Time to time, when I unlock the car with remote and open the door, factory alarm will go off. It is not every time but may be 1 out of 10 times. When the alarm goes off, I just click the unlock button again, it stops. Do you know what may cause this issue?
Connectez-vous pour répondre Voir 2 réponse(s)

28/02/2015

 Toyota Jonas Lara (360Pts.)

1

Ax-One / Evo-One Alarm features / Siren connection / 2015 tundra

I have an Ax-One kit that did not come with the siren although it was listed as coming with one. I ended getting an aftermarket 12V Siren. How do I connect this to the Ax-One ? The guide didnt specify. The siren has a red and black wire but Im not sure how this connects to the unit or my truck. I already turned on the alarm in both the bypass and remote start sections in flashlink and selected siren output. As of right now the Evo-One is not triggering my factory alarm with the shock sensor, only causing the parking lights to blink when the alarm goes off so Im hoping adding the siren will fix this issue.
Connectez-vous pour répondre Voir 1 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer