I installed the Evo One in my daughters 2016 Subaru Legacy Limited with the regular key. I used the "T" harness and wired it as described on the website.
When Lock button is press 3 times, the parking lights flash 3 times. I red in the quick start guide that this means read mode disabled. But could not see where to diagnose this issue.
Programming went fine, All the LED lights did as they were supposed to. Decrypting worked OK.
There are no LED lights lit on the unit at any time while plugged into vehicle. None when hit lock button, none when key is on,
Pressing lock 3 times does nothing, tried unlock, then lock 3 times and nothing.
I did notice the security light on the dash glows very slightly inbetween flashes, and also with the engine running. I connected all the wires as per the wiring diagram The IMO wires are connected at the back of the fuse panel in the White/Blue wire. The Yellow loop is cut as this is an automatic vehicle.
THANK YOU!
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
