Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

Replay clicks when releasing brake pedal while driving.

2011 manual G37, relay in module clicks everytime brake pedal is released while driving.

0

2004 QX56

Will 3x-lock remote start work on a 2004 infiniti QX56? (evo-one)

0

It says to put lock and unlock wires in empty pin spots in BCM plug??

How do i put wires into empty pin slots in BCM plug

0

Infinity qx30. 2018

Solutionnpour infinity qx30 2018

0

Red light is blinking after installation and using Dcryptor , what does that mean?

I connected all the wires, set up the dcryptor but remote start is not working and when I click on lock 3x red flashing light turns on, what might be the issue since everything is connected and remote is encrypted

0

Evo-start2 antenna pair & program

Unable to program Evo-start2 antenna with the Evo one. i've installed the Evo one and it works fine with the factory fob on my 2008 Honda Odysse and try to progam the Evo-start2 antenna and yellow wire connect to an ignition source but i'm unble to get the blue light. when start engine is clicked from the appthe antenna flashes green and then amberbut the car doesn't start.i try reprogramming the antenna so many times but still nothing work. i was try program like this Ignition ON-OFF-ON Press and release the brakes 4 times and the anntenna not to flash rapidly blue Thank You.

0

Add remote start to 2007 Infiniti M35x by using newer OEM fob?

- Is it possible to program/use a newer Infiniti fob (that has an "autostart" button) with the EVO ALL or ONE? The 2007 M35x fob does not have the autostart feature nor autostart button on the fob... so the quesiton is, can the OEM fob essentially be "upgraded" with the EVO unit? ==================================================================================== - OR ... can these EVO units add the capability of autostarting via pushing the lock button 3 times on the orginal fob? =================================================================================== - OR ... must you buy an EVO fob to pair with the EVO ALL or ONE to add remote start capability?

0

2017 Q60 3.0T

Firtsly, is there a solution for my Infiniti Q60 Red Sport (3.0T)?  Wouldn't the EVO All or EVO One with the T-Harness that works on the 2017 Q50 3.0 with Push-to Start work with my car?

 

If the answer to the question is yes, then here are a few more questions.

 

My Q60 has factory remote start.  The remote has the remote start button.  Would I use the remote start button or would I still have to press the lock button 3 times? Would I be able to add an RF Kit?

 

0

G37 EVO-ONE

I have the evo-all with THAR-NIS1 installed in my 2012 G37.  Everything works but there's no 2 way with my directed smartstart; status, diagnostic, ect.  I see now that the evo-one comes with THAR-NIS1 and it cost more.  What's the difference?  If i switched over would i be able to do 2 way?  Would it be as simple as unplugging the evo-all and plugging in the evo-one?  Thanks  

0

Evo-one install on infiniti 2008 G37 6 speed manual but only lock and unlock work. Remote start does not work.

Hi, I’m installing EVO-one with Omega LINKR-TL2 on a 2008 Infiniti G37 6 speed push to start. I follow the installing guide #33251. I flashed the unit up to the latest firmware. Previously I had a DEI XL202 romote start that connected to EVO one. Tested the unit and only lock and unlock working but when attempt to remote start the car. Only see 3 parking light flash. So I though that it could be DEI XL202 is not functioning correctly so replace it with Omega LINKR-TL2 unit but still have the same result. I have been talking to Derek for his assistant and suggested to master reset both the bypass and remote start. Reset the module and reprogram with his suggested selection (BYPASS SIDE: A1-A11 -ON, C1 -ON, REMOTE SIDE: 8.2, 32.2, 33.3 AND 38.2) but have the same result. I’ve been doing a lot of online researching for the passed 2 week but still no luck. (Now only lock and unlock working) Your help will be much appreciated.

0

2006 Infiniti FX35 EVO-ONE intelligent key question

I know that there are reasons why on some installs an RF kit is required. I'm wondering what the reasoning is for an 06 FX35? I did an install with one and the vehicle starts and stops via the factory remote. My plan was to use an RF kit and Drone Mobile but it seems the RF kit isn't needed.

0

(evo one,2004 infiniti g35x,AT,regular key,no Thar) remote starts but dies after 8 sec

evo-one installed in my 2004 infiniti g35x, auto trans, regular key, using a start 2 ant. car starts on the first try but then dies after 8 sec. on second try, cranks only. after a bit if i send a fresh start signal it will do the same thing. Starts, runs 8sec, dies, cranks.

0

EVO-ONE FLASH LIMIT REACHED

I was trying to troubleshoot why my evo-one unit would not let me into the remote starter options, I have the flasher unit, and I can get into the bypass module and options fine but once I click on toggle the screen just hangs. I've tried, everything I can think of, unplugging the unit from the flasher, from the PC, restarting the application, and even rebooting the PC but it's always the same. Once I click on the toggle button, I hear the flasher click and the app just acts like nothing is plugged to the flasher. and now.... After a few attempts at trying different firmware I'm now getting a flash limit exceeded message, I don't understand why these attempts count towards the limit as I'm trying to troubleshoot. Can you please tell me how this can be resolved? thanks, angelo