Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

infiniti evo-all---evo-key

Hello. Is there a diagram (better if it is standalone) for evo-all such a connection on 2015 infinity Q50, like evo-key? By RX-TX

0

2016 infiniti Q7 (diesel)

Hello. I have now installed evo-all (001A07582812) on a 2016 Infiniti Q7 (diesel). With remote start, the ignition opens, but does not start...the turn signals flash 7 times.

0

2016 infiniti Q50 (4 cyl)

If we press the start-stop button once, then the remote start works without problems... If we don’t press it, then after 8-10 attempts it starts starting normally. Power is supplied to ON1, ON2, ON3 and ACC during remote start...Maybe somewhere else need to supply power?

0

2016 infiniti Q50 (4 cyl)

If we press the start-stop button once, then the remote start works without problems... If we don’t press it, then after 8-10 attempts it starts starting normally. Power is supplied to ON1, ON2, ON3 and ACC during remote start...Maybe somewhere else need to supply power?

0

dcryptor limit has been reach for this car. please reset

0

Trying to add RF kit RK441 to EVO ALL 2015 Infiniti Q50

Trying to add RF kit RFK441 to my remote start using EVO ALL and T harness. I flashed it and the remote start is working great using OEM remote. I have the option selected for RF Kit -Fortin 2. I setup EVO ALL to receive the RF kit programming and the red, yellow and blue stay solid during the process and dont flash after pressing the program button listed on instructions. The antenna blink once when I press buttons to program it, but the car doesnt respond to key presses on the RF remote. Any suggestions? 2015 Infiniti Q50, push button start.

0

The Current Device cannot be Flashed anymore

Trying to update the firmware, when connected to the vehicle to program the lights do not turn on. Unit is for a g37s SN: 002504 077873

0

My Remote Start Stopped Working in my G37 Sedan for the RF Controller and OEM controller

My Remote Start has been working just fine since 2017. Lost Remote Start on my oem controller and rf controller. Lock and unlock work fine. Do I need to do an update? Refresh?

0

Module unable to sample vehicle immobilizer data

2005 G35 standard key EVO ALL S/N 001A07 501715 Crime Stopper RS7 remote start I have several documents with programming procedures. I am able to get through these at which point the bypass module flashes red and yellow. I unplug it, take it to the computer for decrytor and it comes back saying unable to sample the vehicles immobilizer data. I have tried re selecting the options in flashlink manager, re flashing the evo all, and re trying the programming features to no avail. It will not decrypt.

0

Problem turning off car remotely.

Hello, We installed EVO All on a 2008 Infinity G37. The car starts remotely from the original alarm key fob, but it is not possible to turn it off from the same key fob, and I would also like to ask for a wiring diagram for the protection button.

0

evo-all (hardware version 6) did not detected with flash manager

service #: 001A06 680087 service #: 001A06 680137 I bought about 14 evo-nist1 products from e-bay. For my Infiniti community members.. Some of them is not new. And I found today just two 2016 product (hardware version 6) evo-all module did not detected with flash manager. It said uncompatible product.. How can I next?

0

EVO-ALL THAR-NIS1 (when the engine is running, the standard keychain does not work)

I have Infiniti G37S coupe 2009 on the European market, everything is connected by the manual, but when the engine is running, the standard key fob does not work, you can open the car only with a metal key, just when you open the door, does the engine stall, what did I do wrong?

0

RFA2A Cable required with NIST1 THarness EVO-All?

I've just purchased (but not yet received) an EVO-All with NIST1 t-harness kit, along with RFK441 remote, reading the instructions it vaguely mentions an "RFA2A" cable. Is this required to make it compatible? Or does the tharness already have the adapter on it? Thanks!

0

evo-all flash jaune et rouge apres avoir programmer l'antenne evo-start 2

J'ai achete evo-all pour avoir un demarreur a distance sur la cle oem mais il manquais de distance alors jai acheter l'antenne evo start 2 toute fonctionnais il decollait apres 3 lock mais apres avoir programmer l'antenne evo start 2 mon module evo all flash rouge et jaune meme apres avoir deconnecter le connecteur 4 pin mais quand je clique sur verouiller ou deverouiller les porte la lumiere de lantenne allume verte mais il ce passe rien

0

Q60 starts but does not shift gears

Heres what happens.... serial#001A07 234189 using 3x lock, the car attempts to start but stalls. A few seconds later, it automatically tries again and succeeds in starting. Upon entering the vehicle, however, i cannot shift out of park. the windows do not go up/down. The car does not lock/unlock using the keyfob. ------------------ i spliced the 2 wires in the white 15-pin connector. I wired them to the red/black cables on the THarness. The ends that run through the wiring harness are the ends i wired(not the ends sticking out of the connector). I'm not sure whats going on.

0

2013 G37 Automatic Lights

I just installed my Evo-All and THar-Nis1 in my 2013 G37xS Coupe. Everything works flawless except for the timed shut off, and when I use the key fob to shut off the engine. My running lights stay on.

0

Add ASCL6 with RFK942

I've installed the EVO ALL with T-Harness (EVO NIST4) and the RFK942 RF kit to my 2016 Infiniti Q50 (3.0T). All works well. I am considering adding the Car Link ASCL6 system to my car. My question is can I use the RFK942 together with the Car Link or will I have to choose between one or the other If I can use both, will I need something added to the existing T-Harness (EVO NIST4) in order to connect them both (such as RFA2A)? Thank you in advance for your help.

0

Q50 parking lights

The parking lights are not turning on and option A14 (Parking Light Control) is ON. I have used the Stand Alone installation with T-Harness (NIST4) guide 75841 (REV 20211130). All other functions appear to be functioning properly. Is there a solution to this problem. Thank you.

0

NIST4 Harness

Is it necessary to cut the 15 pin white connector that contains the red and black wires (power and ground) on the NIST4 harness for the 2016 Infiniti Q50 3.0 as shown on Guide #75841?

 

 Guide # 75841 

 

0

cranks but does not remote start without key in barrel

2004 g35 sedan auto with aftermarket remote starter and evo all unit. did dcryptor and plug into car but cranks and no start. after pressing the button to remote start, the evo all module red and yellow lights came on. cranks but no start. when key in barrel the car starts after pressing remote start. with key in on position, there was yellow light on evo all module.

0

Vehicle starting but messing but

I have a 2014 Infiniti Q50, bought the EVO ALL with the thar-nist4 t harness. installed everything and programmed the module and the vehicle started. going inside the car, tried to press the push to start button and no response whatsoever. pressed the key 3x lock to shut the engine off and it turn off all the electricals but engine stayed on with no control at all. unplugged the module from the wires and vehicle turned off instantly and gained all access to vehicle again. Is there something I am doing wrong or is my EVO-ALL module defected? please help...

0

hello evo all w remote starter installed in g37 everything working except the horn and trunk release from the key fob

0

Wiring-related

Wiring inquiries... Infinity 2017 q70 vehicle. A15 (-)DRIVER DOOR PIN on wiring diagram, The BCM black connection is blue at least. However, the vehicle has the same wiring LT.GREEN Can I connect to that wire? Also, can I connect A16 wiring and A10 yellow wiring as shown in the picture? to be curious Please give me an answer.

0

Add remote start to 2007 Infiniti M35x by using newer OEM fob?

- Is it possible to program/use a newer Infiniti fob (that has an "autostart" button) with the EVO ALL or ONE? The 2007 M35x fob does not have the autostart feature nor autostart button on the fob... so the quesiton is, can the OEM fob essentially be "upgraded" with the EVO unit? ==================================================================================== - OR ... can these EVO units add the capability of autostarting via pushing the lock button 3 times on the orginal fob? =================================================================================== - OR ... must you buy an EVO fob to pair with the EVO ALL or ONE to add remote start capability?

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer