2016 Infinit QX70 EVO-NIST1 Stand-Alone Add-On Remote Start is the Vehicle and Product that is being installed (with harness - not hard wired)
I have confirmed the EVO ALL is configured and programed for the vehicle - no RF controller, stand alone, factory remote (push lock, unlock, lock to start).
I installed the fortin harness and hooked up the PST wire, the park light interface wire, and the vallet switch. I am using the install instructions; Guide #90131
I have successfully programed the unit to the vehicle; yet the problem is the engine will not start.
When I attempt a remote start cycle, the parking lights activate, the radio headunit turns on, the PST engages to ACC, and then the gauge cluster appears on the dash (digital), and then the PST engages to Start (ignition).
But then the vehicle does not start.
If I attempt a remote start in the car while pressing the brake pedal; the system activates.
The brake lights currently function - yet during the remote start cycle, the Fortun system is NOT activating the brake lights during the start up cycle. This appears to be the failure point.
I have checked the connections from the Fortin Product to the brake light switch. I have tried to reset the connection and it is secure. There is no way of reserving the connections.
And per the self help instructions I have not hooked up any other unnessacry Fortin connections.
I am using the RL2 connector to the EVO ALL unit.
I have also confirmed the the vallet switch installed (dark blue) is not grounded or closed during the remote start cycle.
I have read a post where a 2016 Juke had a similar problem where the wires coming from the Fortin Harness were reversed to the factory brake light switch.
Can someone confirm my theory that the problem is the EVO ALL unit is not sending the brake signal during the remote start cycle to the corresponding brake light factory harness? Is it the case where the Fortin plug which connects to the factory brake light swith is missed wired?
I have spent a total of 6 hours of my last two weekends confirming connections, voltage, updating the software versions, and programing the unit but I am stuck at this failure point.
Any kind words or assistance would be helpful.
Thanks!
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
