I have been through the programming steps 3 times. Was somewhat confused as to whether I should push on the brake (as in "hold down brake and push button to start" for normal starting) during programming steps so I tried both ways. Both times, all goes well until step 10 of the programming sequence. With the Blue LED on solid, when pushing the start button once to turn on the ignition, the blue LED turns completely off and does not flash. I read elsewhere in the Dodge FAQ where it was suggested to connect red/green A18 wire to brake pedal wire, but in my install guide (#12211 - Stand Alone for CHRT6 with T Harness for Automatic Trans Only), the connection diagram says to connect wire A18 to the parking light switch wire which is how I have it. Just to note, when I do not press the brake pedal during programming, the car goes to run position, but does not actually start whereas when I do press the pedal, it does. This seems to have no effect either way on the situation with Blue LED (behavior is same either way). I have double checked and can-bus hi/lo wires are correct and not reversed. Hardware version is 6, firmware is 74.25. Thanks for any advice you may have!
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
