I cannot get my EVO-ALL to program properly in stand-alone mode in my 2012 Chevy Cruze (not push button). No matter what I do, in both the standard programming method and the DCryptor method, the very last step with the flashing blue light never occurs. In standard programming, I get to the last part of step 4 after the yellow led flashes 10x and the blue light never flashes. In the DCryptor method, I get to the very last part of step 7 where the blue led turns on, then blue and red turn off, then yellow flashes and then turns off. Again, the blue led never flashes afterward. I went ahead and ran the DCryptor portion in Flash-Link and it seemed to succeed, but I am still unable to start the car in stand-alone mode.
I've double checked my connection to the ODBII connector with the brown wire, and I'm using the THAR-GM1v2 harness. I've also tried a factory reset and flashing older firmware versions. Nothing has made any difference.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
