Installed Evo All CHR6 in 2014 dodge dart, programmed successfully, vehicle starts upon 3x lock, and stops with additional 3x lock. However, when using remote start, it appears to trigger check engine light, and puts engine in "limp" mode, accelerating sluggishly. if I turn vehicle off, and then start normally, without remote start, it runs fine, but engine light stays on. I can reset the light, but as soon as I use remote start, it comes back. I have googled this issue, and it appears I need to connect to a different wire, but not sure which one - I suspect something to do with brake pedal. help please.
additional detail I probably should have added. I started with the firmware version 74 .29, per the install instructions, but that wouldn't program. However I noticed the actual flashlink manager app recommended 74.24. Once I had reflashed it to .24, and it then programmed successfully, took the key details, encrypted successfully, etc.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
