Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

User

Jeff Patton

Joined on the:

Dec. 10, 2013

Score

440

Comment(s)

10

Voted question(s)

0

Voted answer(s)

0

Votes up

0

Votes down

0

Votes up received

5

Votes down received

0

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

0

Are there wires that get connected to the ground and ignition of the bypass module plug with the tx and expect wires

I am having trouble and the install guide appears to have a ground and ignition word from the same connector that the rd and tax wire are connected. However there doesn't seam to be a wire in black print that would go to the ignition and ground wires of that plug.

0

Eco-one will not show powershow power when plugged into car

Flashed the eco-one and now won't flash again and will not show power when plugged into the car

0

can I use the rf unit with eve-all in a mazda 6

I am putting a remote start in a 2005 Mazda 6, can I use the RF unit with the evo-All or do I have to use the evo-one. I do not see instructions for the RF Unit in the Evo-All directions, only the evo-one indstructions. Thank you Jeff

1

Is the 2015 Kia Soul a stand alone or is a remote starter needed, the Eco-one looks to be , Thank You

Is the 2015 Kia Soul a stand alone or is a remote starter needed, the Eco-one looks to be , Thank You

1

2014 Ford Escape won't shut off

I installed a Evo-All and crimestopper RF kit in a 2014 Ford Escape approximately 2 months ago. All has been good, until this morning. Started car with the remote start and it would not shut off. The only way I could turn the car off was to disconnect the power to the Evo-All. The yellow light was on on the Evo-All before I disconnected the power. Any ideas please. I also installed the wiring harness for easier install.

1

Is the rf kit needed for 2014 ford escape stand alone install

I don't have an rf kit, the only stand alone install shows the rf kit install with it

17/03/2014

Ford Fortin User

1

2014 Ford Explorer Stand Alone & T Harness problem .....

I installed a evo all in stand alone with T- harness on a 2014 Ford Explorer with Key. Customer left with everything working fine. Only options i did not hook up from diagram is the hood pin because it has factory hood pin and parking lights. A week or two later customer calls to say she remote started vehicle and got in and drove somewhere and when she arrived at destination she put car in park and took the key out of ignition and the car kept running. She put a her foot on the brake numerous time and hit lock 3x again to disengage but still kept running. I flashed the evo all with the latest recommendation from Flash Link for that car before installation. Please let me know what to start checking for ... The driver door is hooked up correctly because it will not remote start with door open or hood open. Thank you...

1

Anyone know why 2009 Mini Cooper s will not shut off with int-bmw-2 installed

I installed a remote start , evo-all and the int-bmw-2 in my wife's 2009 Mini Cooper. Evo -all seams to have programmed. However the int-bmw-2 would not let the vehicle start for about the 1st 5 minutes after installed. Once it was started with the key in the slot and the button pushed, it would not turn off. I could remove the key from the slot and it would still run. I finally had to disconnect the int-bmw-2 ribbon cables and hook the ignition up direct to turn the car back off. Anyone have any ideas or could I have a bad int-bmw-2.

1

Which directions to use int-bmw2 or evo-all

I contacted support today to ask which directions to use for 2009 Mini Cooper , there are two differences, BMW says to hook the brake though the BMW unit and hook the rf loop through a white/red and white/blue wire on the evo-all. The evo-all says to hook the brake to the evo-all and to use the white two pin connector as the rf loop. I was told to use the BMW directions. I hope this is right the support tech told me to use 7971, that came up as the BMW directions. He was to busy talking over me when I tried to confirm this with him, no where on the BMW directions is 7971 listed and no where on the evo-all directions does it say to refer to the the BMW directions. Can you confirm that this is correct, the tech was kind of rude.

1

starter will not allow the vehicle to turn off?

2011 ford edge ts133 titan starter, THAR-ford1 harness and evo-all by pass. installed the system and it worked. customer comes back and says that the vehicle will not shut off unless you unplug the data link connector. tryed new starter module and new evo all. when i programmed the evo all as soon as i turn the key onn the ignition will stay on. open the hood does not make a difference and neither will the brake. when its running the vehicle is fully operational and drivable with out the key in the ignition. any ideas?

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue