2019 RAM 2500 Push to Start GAS
(What I wired)
THAR-CHR6 Harness: I wired from the EVO ALL A1 to the purple and white on the Igintion BCM module. A10 to Lt.Blue of T harness, A20 to the Lt.Blue/Black of T harness, with an OHM meter I ringed them out (they are connected). I tied the red connector D3 & D1 together and soldeir together at the T harness as discribed. Can 1 LOW connection C4 from the EVO to the Yellow of CAN 1 connector on the truck. Can 1 High connection C3 from the EVO to the Brown and White of CAN 1 connector on the truck.
(plugged it the remaining plugs by the steps discribed into the EVO ALL)
Issue I have: I go though steps 1 & 2, however when I plug the 20 pin connector in the light the blue light goes out. (no lights are on).
I updated and flashed the EVO to Firmware 74.[38] Hardware inside 7.0 however, the the orange box says Recimmended firmware is not loaded 63.[02] then there is a green Update to that version aside it.
What can my issue be. Thank in advance for any help!
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
