Can't find anything in the questions/answers that is exactly like this issue but I can't seem to complete the programming on my truck.. I've double and tripple checked the wiring, can-high/low, key sense A1,A10,A20 were connected as well.
First time it seemed to sense the keys, waited the 3 seconds each and returned to the 1st factory key.. waited for 3 or 4 minutes and no status change so I tried it again. Seemed to go a little further and the system locked/unlocked the doors and the stopped again.. no 10x flash of the indicator either. reflashed the unit and tried again, this time nothing seems to progress. I can put the unit into programming mode (blue/red solid) When I touch a key to the ignition I see a quick flash of the yellow, turn to run and wait 3, 2nd key doesn't show anything.. return to the first key and nothing happens. lights won't change at all and just stuck at solid blue/red. I've tried tapping the button when the key is inserted, but that does nothing either. One really strange issue is I started the truck after (unit was still connected) and it would not shut off until I pulled the connectors off the controller.. brake pedal didn't do anything, opening the door didn't light the interior or turn on the parking lights.
Any ideas? THAR-FORD1 with EVO-ALL
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Buick
Cadillac
Chevrolet
Ford
GMC
Hyundai
Kia
Mazda
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
