EVO one wired to 2011 Hyundai Tucson regular key no blue data wire per evo one install 2011 hyundai tucson installation guide. Evo one has been flashed to recommended firmware for this car, hardware 2. The unit appears to program correctly per program #2 (car has no blue data wire) and blue light flashes rapidly after start. Turn engine off and back to run, and the yellow light remains steady yellow.
The unit is detecting oem keyfob lock and unlock signals (blue can light flashes). 3x lock start has been activated on both remote start and bypass. 3x lock on the oem keyfob initiates remote start...the units red light goes solid red, then yellow light solid also lights up.
This is where the issue is. The car flashes its parking lights one time, and on the dash the indicator for "door open" turns on and the dome light illuminates....but nothing happens. There is no initiation of ignition, accesory or even an attempt at cranking. This sequence happanes twice, and then the unit shuts down. It does appear that the small red indicator light by the yellow "loop" is rapidly flashing during this process, as if the alarm has not been disabled?
I have rechecked all connections numerous times. Correct locations and solid soldered connections. Have tried enabling unlock before start/locl after remote start with the same result.
Tested as both remote start and bypass mode, same results.
SN: 002B01005141
Any help with figuring out how to remote start with 3x lock press greatly appreciated. The fact that the unit responds to oem keyfob presses in encouraging...would love to get RS working.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
